Toyota FJ Cruiser (GSJ 10, 15 series). Instruction — part 362
PB–24
PARKING BRAKE – PARKING BRAKE SWITCH
PB
REMOVAL
1.
DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
2.
REMOVE PARKING BRAKE HOLE COVER SUB-
ASSEMBLY (See page
)
3.
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for
Manual Transmission) (See page
)
4.
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for
4WD) (See page
)
5.
REMOVE CONSOLE UPPER REAR PANEL SUB-
ASSEMBLY (See page
6.
REMOVE PARKING BRAKE SWITCH
(a) Disconnect the parking brake switch connector.
(b) Remove the screw and parking brake switch.
C133100
PARKING BRAKE – PARKING BRAKE SWITCH
PB–25
PB
INSPECTION
1.
INSPECT PARKING BRAKE SWITCH
(a) Check the resistance.
(1) Using an ohmmeter, measure the resistance
between the terminals.
Standard resistance
If the result is not as specified, replace the
parking brake switch.
INSTALLATION
1.
INSTALL PARKING BRAKE SWITCH
(a) Install the parking brake switch with the screw.
(b) Connect the parking brake switch connector.
2.
INSTALL CONSOLE UPPER REAR PANEL SUB-
ASSEMBLY (See page
)
3.
INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for
4WD) (See page
4.
INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for
Manual Transmission) (See page
5.
INSTALL PARKING BRAKE HOLE COVER SUB-
ASSEMBLY (See page
)
6.
CONNECT CABLE TO NEGATIVE BATTERY
TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
Tester Connection
Switch Condition
Specified Condition
1 - Ground
Released
Below 1
Ω
1 - Ground
Pushed in
10 k
Ω or higher
C133100
POWER STEERING – POWER STEERING SYSTEM
PS–1
PS
POWER STEERING SYSTEM
PRECAUTION
1.
HANDLING PRECAUTIONS FOR STEERING SYSTEM
(a) Care must be taken when replacing parts. Incorrect
replacement could affect the performance of the
steering system and result in driving hazards.
2.
HANDLING PRECAUTIONS FOR SRS AIRBAG
SYSTEM
(a) The vehicle is equipped with SRS (Supplemental
Restraint System), such as airbags. If service
operation is not carried out properly in the correct
sequence, the airbag may suddenly deploy and this
may result in serious injury. Before servicing
(including inspection, replacement, removal and
inspection of parts), be sure to read the
precautionary notices for the supplemental restraint
system (See page
).
PS–2
POWER STEERING – POWER STEERING SYSTEM
PS
PROBLEM SYMPTOMS TABLE
ON-VEHICLE INSPECTION
1.
INSPECT DRIVE BELT
(a) Visually check the belt for defects, such as
excessive wear and frayed cords.
If any defects are found, replace the drive belt.
HINT:
Cracks on the rib side of a belt are considered
acceptable. Replace the belt if there are any
missing ribs.
2.
BLEED POWER STEERING SYSTEM
(a) Check the fluid level.
(b) Jack up the front of the vehicle and support it with
stands.
(c) Turn the steering wheel.
(1) With the engine stopped, turn the wheel slowly
from lock to lock several times.
(d) Lower the vehicle.
Symptom
Suspected area
See page
Hard steering
Tires (Improperly inflated)
Power steering fluid level (Low)
Drive belt (Loose)
Front wheel alignment (Incorrect) (2WD)
Front wheel alignment (Incorrect) (4WD)
Steering system joints (Worn)
-
Suspension arm ball joints (Worn) (2WD)
Suspension arm ball joints (Worn) (4WD)
Steering column (Binding)
-
Vane pump
Power steering link (2WD)
Power steering link (4WD)
Poor return
Tires (Improperly inflated)
Front wheel alignment (Incorrect) (2WD)
Front wheel alignment (Incorrect) (4WD)
Steering column (Binding)
-
Power steering link (2WD)
Power steering link (4WD)
Excessive play
Steering system joints (Worn)
-
Suspension arm ball joints (Worn) (2WD)
Suspension arm ball joints (Worn) (4WD)
Intermediate shaft, Sliding yoke (Worn)
-
Front wheel bearing (Worn)
-
Power steering link (2WD)
Power steering link (4WD)
Abnormal noise
Power steering fluid level (Low)
Steering system joints (Worn)
-
Vane pump
Power steering link (2WD)
Power steering link (4WD)
F040449
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст