Toyota FJ Cruiser (GSJ 10, 15 series). Instruction — part 257
INTERIOR – ROOF HEADLINING
IR–31
IR
REASSEMBLY
1.
INSTALL ROOF WIRE
(a) Apply new double-sided tape to the roof headlining
along the markings of the roof headlining.
NOTICE:
•
Apply the tape securely in place.
•
Do not touch the adhesive surface when
applying the tape to prevent adhesion failure.
(b) Install the roof wire as shown in the illustration.
NOTICE:
•
Do not twist the flat wire harness when
installing it.
•
Securely fix the wire harness by pressing it.
Double-sided Tape
Marking
B130653E01
Fixed Tape
A
A
B
Marking Tape
Marking Tape
B130652E01
IR–32
INTERIOR – ROOF HEADLINING
IR
•
Securely fix the wire harness to secure gap
between the wire harness and the roof panel
in part A.
•
Securely fix the wire harness to avoid
looseness in the wire harness between
portion B and the marking tape.
2.
INSTALL ROOF SILENCER PAD
(a) Align 2 new roof silencer pads with the markings of
the roof headlining and install them onto the roof
headlining.
3.
INSTALL ROOF SPEAKER ASSEMBLY
HINT:
Use the same procedure for both sides.
(a) Install the roof speaker by turning it in the direction
of the arrow shown in the illustration.
Marking
B130650E01
for LH Side:
for RH Side:
B138635E01
INTERIOR – ROOF HEADLINING
IR–33
IR
(b) Tighten the screw.
(c) Connect the speaker connector.
INSTALLATION
1.
INSTALL ROOF HEADLINING
(a) Pull the roof headlining back into the vehicle through
the back door.
(b) Install the 4 clips.
for LH Side:
for RH Side:
B135049E01
B130646
B130645
IR–34
INTERIOR – ROOF HEADLINING
IR
(c) Install the 3 clamps and the connector.
(d) Install the clamp.
(e) Connect the 2 connectors.
(f)
Insert the wire harness into the 2 clamps.
2.
INSTALL INSTRUMENT PANEL FINISH LOWER
PANEL SUB-ASSEMBLY (See page
)
3.
INSTALL HOOD LOCK CONTROL LEVER SUB-
ASSEMBLY (See page
4.
INSTALL INSTRUMENT PANEL REGISTER
ASSEMBLY (See page
5.
INSTALL ROOM LIGHT ASSEMBLY
HINT:
The procedure described below is for the front side. Use
the same procedure for both the front and rear sides,
unless otherwise specified.
(a) for Front Side:
(1) Engage the 4 claws and install the room light
switch base.
(2) Insert the 2 wire harnesses into the 2 claws of
the room light.
B130644
B130643
B138411
B138414
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст