Toyota FJ Cruiser (GSJ 10, 15 series). Instruction — part 255
INTERIOR – ROOF HEADLINING
IR–23
IR
43. REMOVE ROOF HEADLINING HOLE PLUG
HINT:
Use the same procedure for both sides.
(a) Using a screwdriver with its tip wrapped in
protective tape, disengage the 3 claws and open the
cover.
(b) Remove the bolt.
(c) Disengage the claw and remove the roof headlining
hole plug.
for RH Side:
for LH Side:
Protective Tape
B130623E01
for RH Side:
for LH Side:
B130625E01
IR–24
INTERIOR – ROOF HEADLINING
IR
44. REMOVE COAT HOOK
HINT:
Use the same procedure for both sides.
(a) Using a screwdriver with its tip wrapped in
protective tape, disengage the claw and open the
cover.
(b) Remove the bolt and the coat hook.
45. REMOVE VISOR ASSEMBLY RH
(a) Remove the visor support shaft from the visor
holder.
(b) Remove the 2 screws and the visor.
46. REMOVE VISOR ASSEMBLY LH
HINT:
Use the same procedure as for the RH side.
for RH Side:
for LH Side:
Protective Tape
B130626E01
for RH Side:
for LH Side:
B130628E01
B130629
INTERIOR – ROOF HEADLINING
IR–25
IR
47. REMOVE VISOR HOLDER
HINT:
Use the same procedure for both sides.
(a) Disengage the 2 claws by turning the visor
counterclockwise between 60 to 120
° and remove
the visor holder.
HINT:
The claw may be damaged during removal.
However, it is reusable because this does not effect
its function.
48. REMOVE INNER REAR VIEW MIRROR STAY
HOLDER COVER (See page
49. REMOVE INNER REAR VIEW MIRROR ASSEMBLY
)
50. REMOVE ROOM LIGHT ASSEMBLY
HINT:
The procedure described below is for the front side. Use
the same procedure for both the front and rear sides,
unless otherwise specified.
(a) Using a screwdriver with its tip wrapped in
protective tape, disengage the 4 claws and remove
the room light lens.
for RH Side:
for LH Side:
60 to 120°
60 to 120°
B130630E01
B138411
Protective Tape
B138408E01
IR–26
INTERIOR – ROOF HEADLINING
IR
(b) Using a screwdriver with its tip wrapped in
protective tape, disengage the 2 claws and remove
the cover.
HINT:
Use the same procedure as for the opposite side.
(c) Using a screwdriver with its tip wrapped in
protective tape, disengage the 4 claws and remove
the room light.
(d) for Front Side:
(1) Remove the 2 wire harnesses from the 2 claws
of the room light.
(2) Using a screwdriver with its tip wrapped in
protective tape, disengage the 4 claws and
remove the room light switch base.
Protective Tape
B138409E01
Protective Tape
B138410E01
Protective Tape
B138413E01
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст