Toyota FJ Cruiser (GSJ 10, 15 series). Instruction — part 256
INTERIOR – ROOF HEADLINING
IR–27
IR
(e) for Rear Side:
(1) Remove the wire harness from the claw of the
room light.
(2) Using a screwdriver with its tip wrapped in
protective tape, disengage the 4 claws and
remove the room light switch base.
51. REMOVE INSTRUMENT PANEL REGISTER
ASSEMBLY (See page
)
52. REMOVE HOOD LOCK CONTROL LEVER SUB-
ASSEMBLY (See page
)
53. REMOVE INSTRUMENT PANEL FINISH LOWER
PANEL SUB-ASSEMBLY (See page
)
54. REMOVE ROOF HEADLINING
(a) Remove the wire harness from the 2 clamps.
(b) Disconnect the 2 connectors.
(c) Using a clip remover, remove the clamp.
(d) Using a clip remover, remove the 3 clamps and the
connector.
Protective Tape
B138412E01
B130643
B130644
IR–28
INTERIOR – ROOF HEADLINING
IR
(e) Using a clip remover, remove the 4 clips.
(f)
Remove the roof headlining from the back door.
B130645
B130646
INTERIOR – ROOF HEADLINING
IR–29
IR
DISASSEMBLY
1.
REMOVE ROOF SPEAKER ASSEMBLY
HINT:
Use the same procedure for both sides.
(a) Disconnect the speaker connector.
(b) Loosen the screw.
(c) Remove the roof speaker by turning it in the
direction of the arrow shown in the illustration.
for LH Side:
for RH Side:
B135049E01
for RH Side:
for LH Side:
B138632E01
IR–30
INTERIOR – ROOF HEADLINING
IR
2.
REMOVE ROOF SILENCER PAD
(a) Remove the 2 roof silencer pads.
3.
REMOVE ROOF WIRE
(a) Remove the roof wire.
B130649
B130651
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст