Toyota FJ Cruiser (GSJ 10, 15 series). Instruction — part 128
ENGINE HOOD / DOOR – FRONT DOOR
ED–9
ED
DISASSEMBLY
HINT:
•
Use the same procedure for both the RH and LH sides.
•
The procedure described below is for the RH side.
1.
DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
2.
REMOVE FRONT ARMREST BASE UPPER PANEL
(a) Disengage the 3 claws and clip and remove the
front armrest base upper panel.
(b) Disconnect the connector.
3.
REMOVE POWER WINDOW REGULATOR MASTER
SWITCH ASSEMBLY (for Driver Side) (See page
4.
REMOVE POWER WINDOW REGULATOR SWITCH
ASSEMBLY (for Front Passenger Side) (See page
5.
REMOVE DOOR CONTROL SWITCH (for Front
Passenger Side) (See page
)
6.
REMOVE FRONT DOOR TRIM BOARD SUB-
ASSEMBLY
(a) for LH side:
Using a screwdriver with its tip wrapped in
protective tape, open the 2 covers.
(b) for RH side:
Using a screwdriver with its tip wrapped in
protective tape, open the 2 covers.
B135557
Protective Tape
B140030E01
Protective Tape
B135568E01
ED–10
ENGINE HOOD / DOOR – FRONT DOOR
ED
(c) Remove the 2 screws.
(d) Disengage the 10 clips.
(e) Disconnect the front door lock remote control cable
and front door inside locking cable and remove the
front door trim board.
7.
REMOVE FRONT NO.2 DOOR SERVICE HOLE
COVER
(a) Remove the 4 screws and front No. 2 door service
hole cover.
8.
REMOVE OUTER REAR VIEW MIRROR
HINT:
Use the same procedure as for the LH side (see page
9.
REMOVE FRONT DOOR GLASS OUTER
WEATHERSTRIP ASSEMBLY
HINT:
Use the same procedure as for the LH side (see page
10. REMOVE FRONT NO. 1 SPEAKER (See page
B135570
B135571
B135572
B135573
ENGINE HOOD / DOOR – FRONT DOOR
ED–11
ED
11. REMOVE FRONT DOOR SERVICE HOLE COVER
(a) Remove the front door service hole cover.
NOTICE:
Remove any tape remaining on the door side.
12. REMOVE FRONT DOOR INSIDE PANEL PLATE
(a) Remove the 4 screws and the front door inside
panel plate.
13. REMOVE FRONT DOOR CHECK ASSEMBLY
(a) Remove the 2 nuts and bolt, then remove the front
door check.
NOTICE:
Do not drop or damage the door check when
removing the bolts.
HINT:
Remove the door check through the service hole.
14. REMOVE FRONT DOOR WEATHERSTRIP
(a) Disengage the 24 clips and remove the front door
weatherstrip.
NOTICE:
Remove any tape remaining on the door side.
B135574
B135575
B138158
B138159
ED–12
ENGINE HOOD / DOOR – FRONT DOOR
ED
15. REMOVE FRONT DOOR GLASS RUN
(a) Remove the front door glass run.
16. REMOVE FRONT DOOR FRAME SUB-ASSEMBLY
FRONT LOWER
(a) Remove the hole plug.
(b) Remove the bolt and screw, then remove the front
door frame sub-assembly front lower.
NOTICE:
Do not drop or damage the front door frame
sub-assembly front lower when removing the
bolt and screw.
17. REMOVE FRONT DOOR LOWER FRAME BRACKET
GARNISH
(a) Remove the bolt and the 2 screws and remove front
door lower frame bracket garnish.
18. REMOVE FRONT DOOR WINDOW FRAME REAR
LOWER
(a) Remove the bolt, then remove the front door
window frame rear lower.
NOTICE:
Do not drop or damage the front door window
frame rear lower when removing the bolt.
B138160
B135578
B138161
B138162
B138163
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст