Toyota FJ Cruiser (GSJ 10, 15 series). Instruction — part 140
ENGINE HOOD / DOOR – BACK DOOR
ED–57
ED
32. INSTALL BACK DOOR SERVICE HOLE COVER
(a) Apply butyl tape to the door panel, then install the
new back door service hole cover as shown in the
illustration.
HINT:
•
When installing the service hole cover, pull the
links and connectors out through the service
hole.
•
There should be no wrinkles or folds after
attaching the service hole cover.
•
After attaching the service hole cover, check the
quality of the seal.
33. INSTALL BACK DOOR TRIM BOARD
(a) Engage the 16 clips and install the back door trim
board.
(b) Install the 2 screws.
34. INSTALL DOOR TRIM RETAINER CAP
(a) Engage the 2 claws and install the door trim retainer
cap.
35. INSTALL BACK DOOR TRIM COVER RH
(a) Engage the 3 claws and back door trim cover.
36. INSTALL BACK DOOR TRIM COVER LH
HINT:
Use the same procedure as described for the RH side.
B135595
B135554
B135553
B139382
ED–58
ENGINE HOOD / DOOR – BACK DOOR
ED
37. INSTALL SPARE WHEEL CARRIER BRACKET SUB-
ASSEMBLY
(a) Install the spare wheel carrier bracket with the 2
bolts and 2 nuts.
Torque: 48 N*m (489 kgf*cm, 35 ft.*lbf)
38. INSTALL BACK DOOR OUTSIDE MOULDING RH (See
page
39. INSTALL BACK DOOR OUTSIDE MOULDING LH (See
page
40. INSTALL SPARE DISC WHEEL
Torque: 88 N*m (897 kgf*cm, 65 ft.*lbf)
41. CONNECT CABLE TO NEGATIVE BATTERY
TERMINAL
Torque: 3.9 N*m (40 kgf*cm, 35 in.*lbf)
B135543
ED–58
ENGINE HOOD / DOOR – BACK DOOR SUPPORT
ED
BODY
ENGINE HOOD / DOOR
BACK DOOR SUPPORT
COMPONENTS
BACK DOOR
SUPPORT
CLIP
CLIP
B139383E01
ENGINE HOOD / DOOR – BACK DOOR SUPPORT
ED–59
ED
REMOVAL
1.
REMOVE BACK DOOR SUPPORT
(a) Using a screwdriver with its tip wrapped in
protective tape, remove the 2 stop rings and back
door support.
NOTICE:
•
Do not touch the rod of the back door support
with gloves, to avoid fibers from adhering.
•
When foreign matter adheres to the rod, it
prevents the rod from moving smoothly and
reduces its holding power.
INSTALLATION
1.
INSTALL BACK DOOR SUPPORT
(a) Install the 2 stop rings onto the back door support.
(b) Install the back door support.
DISPOSAL
1.
DISPOSE OF BACK DOOR SUPPORT
(a) Horizontally fix the back door support in a vise with
the piston-rod pulled out.
(b) Wearing protective glasses, using a metal saw
gradually cut the shaded part between A and B,
shown in the illustration, to gradually release the
gas.
Specification
CAUTION:
•
Cover the area that is being cut with a shop
rag or a piece of cloth because there is a
possibility that metal shards may be
dispersed by the gas.
•
The gas is colorless, odorless and harmless.
B135594
B135599
A
B
a
b
B135600E01
Area
Measurement
a
80 mm (3.15 in.)
b
20 mm (0.80 in.)
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст