Toyota FJ Cruiser (GSJ 10, 15 series). Instruction — part 204
ET–46
EXTERIOR – ROOF DRIP SIDE FINISH MOULDING
ET
ROOF DRIP SIDE FINISH
MOULDING RETAINER
5.0 (50, 44 in.*lbf)
N*m (kgf*cm, ft*lbf) : Specified torque
Non-reusable part
WINDSHIELD OUTSIDE
UPPER MOULDING
SUB-ASSEMBLY
B135037E01
EXTERIOR – ROOF DRIP SIDE FINISH MOULDING
ET–47
ET
ASSIST GRIP
ASSEMBLY
ASSIST GRIP PLUG
FRONT DOOR OPENING
TRIM WEATHERSTRIP
FRONT PILLAR
GARNISH
FRONT PILLAR
OUTER GARNISH
Non-reusable part
ROOF SIDE GARNISH
PROTECTOR
N*m (kgf*cm, ft*lbf) : Specified torque
5.0 (50, 44 in.*lbf)
x4
B135012E01
ET–48
EXTERIOR – ROOF DRIP SIDE FINISH MOULDING
ET
REMOVAL
HINT:
The procedure described below is for the LH side. Use the
same procedure for both the RH and LH sides, unless
otherwise specified.
1.
REMOVE ROOF DRIP SIDE FINISH MOULDING
JOINT COVER
HINT:
Use the same procedure to remove all the roof drip
moulding joint covers.
(a) Disengage the 2 claws and remove the roof drip
moulding joint cover.
2.
REMOVE NO. 1 ROOF DRIP SIDE FINISH MOULDING
(a) Disengage the clip and remove the No. 1 roof drip
side finish moulding.
NOTICE:
•
Do not remove the clip.
•
Replace the clip with a supply clip if
damaged.
3.
REMOVE NO. 2 ROOF DRIP SIDE FINISH MOULDING
(a) Remove the No. 2 roof drip side finish moulding.
4.
REMOVE NO. 3 ROOF DRIP SIDE FINISH MOULDING
(a) Remove the No. 3 roof drip side finish moulding.
B135000
B135001
B135003
B135005
EXTERIOR – ROOF DRIP SIDE FINISH MOULDING
ET–49
ET
5.
REMOVE NO. 4 ROOF DRIP SIDE FINISH MOULDING
(a) Disengage the clip and remove the No. 4 roof drip
side finish moulding.
NOTICE:
•
Do not remove the clip.
•
Replace the clip with a supply clip if
damaged.
6.
REMOVE WINDSHIELD OUTSIDE UPPER MOULDING
SUB-ASSEMBLY
(a) Apply protective tape to the roof panel in the area
around the windshield outside upper moulding.
(b) Insert the piano wires between the vehicle body and
the windshield outside upper moulding, as shown in
the illustration.
(c) Tie objects that can serve as handles (for example,
wooden blocks) to all wire ends.
NOTICE:
When separating the windshield outside upper
moulding from the vehicle, do not damage the
vehicle's paintwork or exterior ornaments.
(d) Disengage the 6 claws and the 2 clips and remove
the windshield outside upper moulding.
B135007
Protective Tape
B135038E01
B138614
B135039
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст