Ford Galaxy / Ford S-MAX. Manual — part 46
2. General Equipment:
Transmission jack
3. Install the spacer between the rear lower arm
and the body side rail. Make sure that the
spacer is in a vertical plane and raise the
suspension to the design height setting.
4.
1. Torque: 8 Nm
2. Torque: 120 Nm
5. Install the spring.
Refer to:
Spring
(204-02 Rear Suspension,
Removal and Installation).
6. Check the toe setting and adjust as necessary.
Refer to:
Rear Toe Adjustment
(204-00
Suspension System - General Information,
General Procedures).
Refer to:
Specifications
(204-00 Suspension
System - General Information, Specifications).
Rear Suspension - Rear Stabilizer Bar
S-MAX/Galaxy 2006.5 (02/2006-)
Removal and Installation
General Equipment
Removal
Installation
Hydraulic press
1. Remove the stabilizer bar link.
Refer to:
Rear Stabilizer Bar Link
(204-02 Rear
Suspension, Removal and Installation).
2.
3.
1. Install the stabilizer bar bushings with no
lubricant. Make sure the bushing nipple is on the
right-hand side.
2.
NOTE: Apply water to the stabilizer bar
clamp to assist installation.
General Equipment:
Hydraulic press
3. Torque: 48 Nm
4. Install the stabilizer bar link.
Refer to:
Rear Stabilizer Bar Link
(204-02 Rear
Suspension, Removal and Installation).
Rear Suspension - Rear Stabilizer Bar Link
S-MAX/Galaxy 2006.5 (02/2006-)
Removal and Installation
Removal
NOTE: Removal steps in this procedure may contain installation details.
Installation
1. Raise and support the vehicle.
Refer to:
Lifting
(100-02 Jacking and Lifting,
Description and Operation).
2.
CAUTION: Make sure that the ball joint
ball does not rotate.
1. Torque: 60 Nm
2. Torque: 15 Nm
1. To install, reverse the removal procedure.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст