Ford Ranger EV (2001 year). Manual — part 53
303-01-6
303-01-6
Basic Motor/Transaxle
GENERAL PROCEDURES
Oil Level Check Procedure
1. Raise and support the vehicle. Refer to
2. Remove the LH rear wheel.
1 Remove the center cap.
2 Remove the lug nuts.
3 Remove the wheel.
3. Remove the oil fill plug. The motor/transaxle
should be filled to the bottom of the fill plug
hole.
4. Fill the transaxle to the bottom of the fill plug
hole using a clean funnel and hose.
303-01-7
303-01-7
Basic Motor/Transaxle
GENERAL PROCEDURES (Continued)
5. Install the fill plug.
6. Install the wheel.
1 Position the wheel.
2 Install the lug nuts.
3 Install the center cap.
Oil Change Procedure
Special Tool(s)
Electric Motor/Transaxle Test
Box
418-F211
NOTE: The oil capacity of the motor/transaxle is
approximately 1600 ml (54 oz). This procedure will
remove 1000 ml (33 oz) of oil from the
motor/transaxle.
1. Plug the Electric Motor/Transaxle Test Box
power cord into the cigarette lighter.
303-01-8
303-01-8
Basic Motor/Transaxle
GENERAL PROCEDURES (Continued)
3. Remove the LH rear wheel.
1 Remove the center cap.
2 Remove the lug nuts.
3 Remove the wheel.
4. Disconnect the oil pump electrical connector.
5. Connect the Electric Motor/Transaxle Test Box
electrical connector to the oil pump connector.
6. Position a catch pan under the motor/transaxle.
7. Remove the motor/transaxle drain plug.
303-01-9
303-01-9
Basic Motor/Transaxle
GENERAL PROCEDURES (Continued)
8. Turn the Electric Motor/Transaxle Test Box
power on. This will activate the oil pump and
force the oil out of the motor/transaxle. Leave
the power on for two minutes.
9. Install the drain plug.
10. Disconnect the Electric Motor/Transaxle Test
Box electrical connector from the oil pump
connector and connect the oil pump electrical
connector.
11. Disconnect the Electric Motor/Transaxle Test
Box power cord from the cigarette lighter.
12. Remove the oil fill plug.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст