Ford Ranger EV (2001 year). Manual — part 68
307-05-18
307-05-18
Automatic Transaxle External Controls
REMOVAL AND INSTALLATION (Continued)
8. Disconnect the shift cable from the shift lever.
9. Lower the motor/transaxle approximately 2.5
cm (1 in).
10. Remove the motor/transaxle mount.
11. NOTE: The motor/transaxle is shown removed
from the vehicle for clarity.
NOTE: The motor/transaxle must be in the N
(Neutral) position prior to installation of the
DTR sensor.
Position the motor/transaxle in N (Neutral).
•
The N (Neutral) position is two positions
from the shift lever’s most forward position.
307-05-19
307-05-19
Automatic Transaxle External Controls
REMOVAL AND INSTALLATION (Continued)
12. Remove the digital transmission range (DTR)
sensor lever.
1 Remove the nut.
2 Remove the lever.
13. Disconnect the DTR sensor electrical connector.
14. Remove the DTR sensor.
1 Remove the two bolts.
2 Pry the bracket away from the
motor/transaxle.
3 Remove the DTR sensor.
Installation
1. Verify that the gear selector is in the N
(Neutral) position.
307-05-20
307-05-20
Automatic Transaxle External Controls
REMOVAL AND INSTALLATION (Continued)
2. Install the digital TR sensor alignment tool on
the sensor.
3. NOTE: The sensor is installed with alignment
tool in place.
Install the DTR sensor.
1 Position the sensor on the motor/transaxle.
2 Install the bolts.
4. Connect the DTR sensor electrical connector.
307-05-21
307-05-21
Automatic Transaxle External Controls
REMOVAL AND INSTALLATION (Continued)
5. Install the DTR sensor lever.
1 Position the lever.
2 Install the nut.
6. Position the motor/transaxle mount.
7. Install the five bracket to motor/transaxle bolts.
•
The motor/transaxle may have to be lowered
or raised slightly to align the bracket bolt
holes with the motor/transaxle.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст