Ford Ranger EV (2001 year). Manual — part 66
307-05-10
307-05-10
Automatic Transaxle External Controls
DIAGNOSIS AND TESTING (Continued)
PINPOINT TEST B: DIGITAL TRANSMISSION RANGE (DTR) SENSOR ALIGNMENT VERIFICATION
TEST STEP
ACTION TO TAKE
B1 VERIFY DIGITAL TRANSMISSION RANGE (DTR) SENSOR
ALIGNMENT
•
With key OFF, set the gear selector to the PARK position.
Yes =
REPLACE the
motor/transaxle. REFER to
NOTE: Check to make sure the DTR sensor harness connector C4996 is
No =
ADJUST the DTR sensor.
fully seated and the terminals are fully engaged in the connector and in
good condition before proceeding.
•
Apply the parking brake.
•
Set the gear selector to NEUTRAL and verify the shift linkage is
section.
adjusted in the NEUTRAL position.
•
With the gear selector in NEUTRAL, verify Digital TR Sensor
Alignment Tool fits in the appropriate slots.
•
Is the DTR sensor correctly adjusted?
GENERAL PROCEDURES
PRNDE Shifter Adjustment
1. NOTE: The shift cable clip is located on the
rear of the motor/transaxle to the left of the
motor/transaxle rear mount.
Release the cable clip (push up).
2. NOTE: A three-pound weight is required to
hold the shifter in place while the rest of the
procedure is performed.
Place the shifter in D (Drive) and place the
indicator in the center of the D (Drive) position.
307-05-11
307-05-11
Automatic Transaxle External Controls
GENERAL PROCEDURES (Continued)
3. NOTE: The D (Drive) position is one position
from the shift lever’s most rearward position.
Position the motor/transaxle shift lever in D
(Drive).
4. Engage the cable clip (push down).
5. Verify that the shifter has remained in the D
(Drive) position and check for correct gearshift
operation.
Digital Transmission Range (DTR) Sensor Alignment
Special Tool(s)
Digital Transmission Range
(TR) Sensor Alignment Tool
T97L-70010-A
1. Place the gear selector in the N (Neutral)
position.
307-05-12
307-05-12
Automatic Transaxle External Controls
GENERAL PROCEDURES (Continued)
3. Disconnect the shift cable from the shift lever.
NOTE: The motor/transaxle is shown removed from
the vehicle.
4. Remove the shift lever.
1 Remove the nut.
2 Remove the shift lever.
5. Loosen the sensor bolts.
307-05-13
307-05-13
Automatic Transaxle External Controls
GENERAL PROCEDURES (Continued)
6. NOTE: Do not remove the alignment tool until
the sensor bolts have been tightened.
Install the digital TR sensor alignment tool to
positively locate the sensor in relation to the
motor/transaxle neutral position.
7. Tighten the sensor bolts.
8. Remove the digital TR sensor alignment tool.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст