Ford Ranger EV (2001 year). Manual — part 67
307-05-14
307-05-14
Automatic Transaxle External Controls
GENERAL PROCEDURES (Continued)
9. Install the shift lever.
1 Install the shift lever.
2 Install the nut.
10. Connect the shift cable to the shift lever.
11. Adjust the shift cable. Refer to
REMOVAL AND INSTALLATION
Motor/Transaxle Shift Cable
Removal
1. Remove the traction battery. Refer to
Section
307-05-15
307-05-15
Automatic Transaxle External Controls
REMOVAL AND INSTALLATION (Continued)
2. Disconnect the shift cable from the digital
transmission range (DTR) sensor shift lever.
3. Disconnect the shift cable from the bracket.
1 Depress the tabs.
2 Slide the cable through the bracket.
4. Unclip the shift cable from the four clips
located inside the driver side frame rail.
5. NOTE: The shift cable connection is located
under the driver side dash on the steering
column. The shift cable connects to the steering
column and the motor/transaxle in the same
way.
Disconnect the shift cable from the steering
column.
307-05-16
307-05-16
Automatic Transaxle External Controls
REMOVAL AND INSTALLATION (Continued)
6. Disconnect the shift cable from the bracket.
•
Depress the tabs.
•
Slide the cable through the bracket.
7. Remove the cable.
Installation
1. To install, reverse the removal procedure.
•
After installation, adjust the shift cable.
Refer to
Digital Transmission Range (DTR) Sensor
Special Tool(s)
Digital Transmission Range
(TR) Sensor Alignment Tool
T97L-70010-A
Removal
1. Place the gear selector in the N (Neutral)
position.
2. Raise and support the vehicle. Refer to
3. Support the motor/transaxle using a high lift
jack.
4. Remove the LH rear wheel.
307-05-17
307-05-17
Automatic Transaxle External Controls
REMOVAL AND INSTALLATION (Continued)
5. Remove the motor mount through bolt.
6. Remove the two motor mount nuts.
7. Remove the five motor mount bracket to
motor/transaxle bolts.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст