Ford Ranger EV (2001 year). Manual — part 190
414-03B-156
414-03B-156
High Voltage/Traction Battery — Nickel Metal Hydride
REMOVAL AND INSTALLATION (Continued)
Modules 13-15
10. Disconnect the necessary module.
•
Disconnect the HVJ cables and discard the
nuts.
11. Using the special tool, remove the module.
Installation
1. NOTE: The arrow on the battery hold down tie
bars must be pointed towards the front of the
traction battery.
To install, reverse the removal procedure.
•
Fill the high-voltage jumper connectors with
Nyogel after final tightening of the nuts.
414-03B-157
414-03B-157
High Voltage/Traction Battery — Nickel Metal Hydride
REMOVAL AND INSTALLATION (Continued)
414-03B-158
414-03B-158
High Voltage/Traction Battery — Nickel Metal Hydride
REMOVAL AND INSTALLATION (Continued)
Traction Battery Module — Modules 17, 18, 21
Special Tool(s)
Battery Post Torque Wrench
307-026
Battery Terminal Cap Opener
418-F215
Battery Handles
414-F001
Removal
1. This procedure contains steps specific to the
modules listed. Do not start with this procedure.
Refer to
414-03B-159
414-03B-159
High Voltage/Traction Battery — Nickel Metal Hydride
REMOVAL AND INSTALLATION (Continued)
2. Remove the blower cover.
1 Remove the four bolts (two each side).
2 Remove the blower cover.
3. Disconnect the blower electrical connector.
4. Remove the flow through blower.
1 Remove the nuts.
2 Remove the blower.
5. Disconnect the high-voltage connector.
1 Loosen the bolts.
2 Disconnect the connectors.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст