Ford Falcon. Manual — part 250
307-05-3
Automatic Transmission External Controls
307-05-3
DIAGNOSIS AND TESTING
Automatic Transmission External
Controls
Connector Circuit Reference
Loom PCB
Pin Number(s)
Circuit Designation/Description
Normal Condition/Measurement
2 & 3
5V Power Supply through
5V
4.7kOhm resistor
1 & 3
Voltage Measure
Position ‘D’ — 3.96V
Position ‘DPEPF’ — 2.88V
Position ‘+’ — 1.83V
Position ‘–’ — 0.78V
G77032 en
307-05-4
Automatic Transmission External Controls
307-05-4
GENERAL PROCEDURES
Selector Cable Adjustment
1. Move Selector to "P" position.
2. Raise the vehicle and ensure the transmission
operating lever is also in "P" (this is the most
Rearward position).
3. Connect the Cable to the Transmission Cable
Mount by pushing rearwards until the side tabs of
the cable click into the lock position.
NOTE: The Cable Push Rod is snapped onto the Pin.
Finally the adjuster clip is pushed closed on the Cable
auto adjuster.
G77033 en
307-05-5
Automatic Transmission External Controls
307-05-5
REMOVAL AND INSTALLATION
Handle Assembly
Torsion Spring
Removal
1. Remove Centre Console and other associated
components. For additional information, refer to
Section 501-12.
NOTE: Do not remove Gearshift assembly from
the vehicle.
2. Move Handle to "P" position.
3. Open the spring legs with pliers and disengage
from the nest.
Removal and Installation
NOTE: Do not remove console and other associated
components from the vehicle.
1. Move Handle to "D" position.
2. Remove
screw.
3. Remove
Handle.
4. Remove torsion spring. Fit new spring.
Installation
1. To install, reverse the removal procedure.
Housing Sub Assembly
Removal
1. Remove Centre Console and other associated
components. For additional information, refer to
Section 501-12.
NOTE: Do not remove Gearshift assembly from
the vehicle.
Item
Description
2. Disconnect main loom from Plug then Plug from
1
Selector handle
base (squeeze clips).
2
Screw
3. Repeat process for the top LH corner of the
shifter.
4. Insert new Handle then secure with screw.
G77034 en
307-05-6
Automatic Transmission External Controls
307-05-6
REMOVAL AND INSTALLATION (Continued)
4. Lift corner labeled "A" first using narrow nose
3. Move Cover slide hole to "D" position.
pliers placing them between the Housing
4. Slide Housing assembly onto Lever through
assembly and base.
Cover slide hole.
5. Place Housing assembly into Bezel recesses then
push down until locked into the Base.
6. Clip Plug into Base.
7. Connect main loom.
Gear Indicator Globe
Removal
1. Remove Centre Console and other associated
components. For additional information, refer to
Section 501-12.
NOTE: Do not remove Gearshift assembly from
the vehicle.
2. Remove the handle assembly. For additional
5. Squeeze flexible legs with pliers and lift until
information, refer to Handle Assembly in this
disengaging the base.
section.
3. Remove the housing assembly. For additional
information, refer to Housing Sub Assembly in this
section.
6. Lift Housing assembly until disconnected from
lever.
7. Turn Globe holder with pliers until holder can be
pulled out of lower Housing.
Item
Description
8. Remove
Housing
assembly.
1
Selector handle
Installation
2
Screw
1. Insert Globe holder inside lower housing then
rotate approx 45 deg.
3
Housing assembly
2. Move orange indicator into the "D" position.
G77034 en
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст