Ford Falcon. Manual — part 251
307-05-7
Automatic Transmission External Controls
307-05-7
REMOVAL AND INSTALLATION (Continued)
4. Pull out Globe from globe holder.
3. Remove the housing assembly. For additional
information, refer to Housing Sub Assembly in this
section.
5. Push new Globe into Globe holder.
Installation
1. To install, reverse the removal procedure. For
additional information, refer to Housing Sub
Assembly.
Cap
Removal
1. Remove Centre Console and other associated
components. For additional information, refer to
Section 501-12.
NOTE: Do not remove Gearshift assembly from
the vehicle.
2. Remove the handle assembly. For additional
information, refer to Handle Assembly in this
section.
Item
Description
1
Selector handle
2
Screw
3
Housing assembly
4. Move Lever into Tip position.
5. Remove damaged Cap by lifting the face above
the clip, and slide out.
G77038 en
307-05-8
Automatic Transmission External Controls
307-05-8
REMOVAL AND INSTALLATION (Continued)
6. Fit new Cap, pushing onto arm until clipped.
2. Remove the handle assembly. For additional
information, refer to Handle Assembly
Replacement in this section.
3. Remove the housing assembly. For additional
information, refer to Housing Sub Assembly in this
section.
Installation
1. To install, reverse the removal procedure.
Loom PCB (Printed Circuit Board)
Removal
Item
Description
1. Remove Centre Console and other associated
1
Selector handle
components. For additional information, refer to
Section 501-12.
2
Screw
NOTE: Do not remove Gearshift assembly from
3
Housing assembly
the vehicle.
G77038 en
307-05-9
Automatic Transmission External Controls
307-05-9
REMOVAL AND INSTALLATION (Continued)
4. Cut off tab with sharp blade.
Guide Lever
Removal
1. Remove Centre Console and other associated
components. For additional information, refer to
Section 501-12.
NOTE: Do not remove Gearshift assembly from
the vehicle.
2. Remove the handle assembly. For additional
information, refer to Handle Assembly
Replacement in this section.
3. Remove the housing assembly. For additional
information, refer to Housing Sub Assembly
Replacement in this section.
5. Remove faulty Loom PCB.
6. Place new Loom PCB.
7. Secure new Loom PCB with screw provided in the
kit.
Item
Description
1
Selector handle
2
Screw
3
Housing assembly
Installation
1. To install, reverse the removal procedure.
G77039 en
307-05-10
Automatic Transmission External Controls
307-05-10
REMOVAL AND INSTALLATION (Continued)
4. Move Lever into Tip position.
7. Open two clips and push out Guide lever.
5. Press and lift to unclip in the order shown below.
Installation
1. To install, reverse the removal procedure.
Gearshift Assembly
Removal
1. Raise the vehicle and disconnect the transmission
shift cable from the lower selector lever.
I6
V8
6. Move Handle to "D" position.
G77039 en
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст