Ford Falcon. Manual — part 338
413-07-1 Clock 413-07-1
SECTION : 413-07 Clock
VEHICLE APPLICATION : 2003.0 BA Falcon
CONTENTS
PAGE
SPECIFICATIONS
Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 413-07-2
DESCRIPTION AND OPERATION
Clock . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .413-07-3
DIAGNOSIS AND TESTING
Clock . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .413-07-4
Inspection and Verification . . . . . . . . . . . . . . . . . . . . . . . . ...413-07-4
Symptom
Chart
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 413-07-4
Pinpoint
Tests
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..413-07-4
REMOVAL AND INSTALLATION
Clock . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .413-07-6
413-07-2 Clock 413-07-2
SPECIFICATIONS
General Specifications
Description
Specification
Time keeping accuracy
Better than 5 seconds
variation per day
Fixings
Inter-locking tabs plus
two clips
G73347 en
413-07-3 Clock 413-07-3
DESCRIPTION AND OPERATION
Clock
To adjust the time displayed, press and hold the left
button (to turn the clock backwards) or the right button
(to turn the clock forwards).
Press momentarily for fine adjustment, or press and
hold for fast adjustment.
G86736 en
413-07-4 Clock 413-07-4
DIAGNOSIS AND TESTING
Clock
Inspection and Verification
Visual Inspection Chart
Mechanical
Two clips fully engaged
Interlocking fingers properly engaged
Margins are consistant
Electrical connector connected
Symptom Chart
Condition
Source
Action
Wiring fault
Illumination not working
Go to PinPoint Test A
Cluster fault
Clock fault
Wiring fault
Clock not working at all
Go to PinPoint Test B
Clock fault
Clock gains / looses time
Clock fault
Go to PinPoint Test C
Clock minute hand turns at seconds
Clock fault - loss of calibration
Replace Clock
speed
Wiring fault
Clock set buttons not working.
Go to PinPoint Test B
Clock fault
Pinpoint Tests
PINPOINT TEST A : ILLUMINATION TEST
Test Step
Result / Action to Take
A1
CONTROLS CHECK
Turn ignition on.
Yes
Functioning correctly
Turn Park Lamps on.
No
Vary the illumination controls on the IC.
Go to A2
Does the illumination change?
A2
CONTROLS CHECK CONT.
Yes
Go to A3
Does the IC display illumination vary.
No
Refer to IC diagnostics.
A3
CORRECT CONNECTION CHECK
Remove Clock from Instrument panel.
Yes
Go to A4
Is the connector fully engaged?
No
Engage connector and check functionality. Go to
A1 if necessary.
G86737 en
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст