Ford Falcon. Manual — part 355
414-02-13
Alternator and Regulator
414-02-13
DIAGNOSIS AND TESTING (Continued)
Test Step
Result / Action to Take
I2
CHECK THE VOLTAGE GAUGE OPERATION
With the engine running, monitor the voltage gauge reading and the
Yes
battery voltage.
The charging system is operating normally.
Are the voltage readings consistent?
No
Check Instrument Cluster section to continue
diagnostics.
PINPOINT TEST J : THE ALTERNATOR IS NOISY
Test Step
Result / Action to Take
J1
CHECK FOR ACCESSORY DRIVE NOISE
Check the drive belt for damage and verify the installation.
Yes
Go to J2
Check the alternator mounting for loose bolts or misalignment.
No
Check for a bent alternator pulley.
For further diagnostics, refer to the Accessory
Is everything OK?
Drive System section.
J2
SUBSTITUTE A KNOWN GOOD ALTERNATOR
Key in OFF position.
Yes
INSTALL the original alternator and CHECK
Disconnect The alternator connector C161.
other accessories to FIND the cause of the
noise.
Install a known good alternator.
Start up the engine.
No
REPLACE the alternator.
Is the noise present with a known good alternator?
RETEST the system for normal operation.
G86728 en
414-02-14
Alternator and Regulator
414-02-14
REMOVAL AND INSTALLATION
Alternator Installation — 6 Cylinder
Alternator Installation — 8 Cylinder
Removal
Removal
1. Disconnect the battery ground cable. For
1. Disconnect the battery ground cable. For
additional information, refer to Section 414-01.
additional information, refer to Section 414-01.
2. Remove the Front End Accessories Drive belt,
2. Remove the Front End Accessories Drive belt,
For additional information, refer to Section
For additional information, refer to Section
303-05.
303-05.
3. Remove the Nut from connector B on the
3. Remove the Nut on the B connector and remove
alternator and remove wiring from alternator.
wiring from Alternator Wiring Harness.
4. Remove the 5 M8 Bolts holding the Alternator in
4. Remove the 4 Upper Bracket bolts.
place.
5. Remove the 2 lower retaining bolts and remove
the alternator.
5. Remove
the
Alternator.
Installation
Installation
1. To reinstall, reverse the Removal Procedure.
1. To reinstall, reverse the Removal Procedure.
G86729 en
415-00-1
Entertainment System — General Information
415-00-1
SECTION : 415-00 Entertainment System —
General Information
VEHICLE APPLICATION : 2003.0 BA Falcon
CONTENTS
PAGE
DIAGNOSIS AND TESTING
Audio System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 415-00-2
Principles of Operation . . . . . . . . . . . . . . . . . . . . . . . . . . .415-00-2
Self
Tests
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .415-00-2
Function
Tests
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . ..415-00-2
DTC
Chart
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 415-00-3
Symptom
Chart
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 415-00-4
PID
Chart
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .415-00-5
Service
Procedures
. . . . . . . . . . . . . . . . . . . . . . . . . . . ..415-00-6
415-00-2
Entertainment System — General Information
415-00-2
DIAGNOSIS AND TESTING
Parameter identifiers (PID’s)
Audio System
Module configuration
Principles of Operation
Module Configuration
The following diagnostics are available by connecting
The CDU has the following configuration options:
the WDS tester to the diagnostic link connector
located on the right hand side of the fuse box.
Audio security
Sonar parking enable/disable on premium sound
audio
Module configuration is carried out by using the WDS
tester.
Self Tests
The following tests are carried out within seconds,
during the On Demand Self Test.
Antenna connection
Speaker line short circuit
Subwoofer connection
Speaker tone test
AM signal strength check
The WDS tester will support the following modes
FM signal strength check
Self tests
Subwoofer speaker short circuit
Service Procedures (Using the Data Logger
Trip computer data unavailable
function )
Invalid vehicle speed data
Diagnostic trouble codes (DTC’s)
Invalid ambient temperature data
On Demand Self Test
Step
Test
Action
1
Connect WDS tester
—
Turn radio on
Tune FM radio to known station and set
one of the presets.
Carry out self test
2
Speaker tone test function
Listen to speakers.
Tone to each speaker is 1.5 sec on and
0.5 sec off.
Sequence.
Front right > rear right > rear left > front
left
NOTE: Subwoofer output is not tested
3
Is DTC logged
Refer to DTC chart
4
For AM signal strength tune to known AM
—
station set a preset and repeat the above
test
Function Tests
Function test
Description
Steering wheel switch test
Tests steering wheel switches and wiring and identifies
faulty circuit
ICC switch test
Tests audio switch functionality and identifies faulty switch
or function
Input status test
Subwoofer Is Subwoofer connected
G68759 en
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст