Chery B14. Manual — part 19
4.22 Loose safety lock pull rod fixing clip by hand.
4.23 Loose inside control cable fixing clip by hand.
4.24 Disassemble three front door lock fixing bolts by spline
wrench. Installation torque is 9±1N.m
(With thread locking rubber)
4.25 Rotate the lock cable direction to a certain degree and
take off the cable plug. Take out the lock assembly.
4.26 Disassemble the front door handle fixing screw by
spline wrench. Installation torque is 8±1 Nm
4.27 Prize the front door lock core fixing screw protecting
panel by flat head screwdriver.
4.28 Disassemble front door lock core fixing screws.
Note: The shim between lock core, door handle and car door
can not be ignored. Make sure assemble it during installation.
Otherwise it will influence the clearance between them.
Installation torque is 9±1 Nm
4.29 Take out lock core and handle assembly.
4.30 Loose two front door stopper fixing bolts by No.13
spanner. (See disassembly of front door hinge and stopper).
Torque is 36±4N.m.
4.31 Front door stopper is connected to body by a flexible
eye pin. This flexible eye pin is an elasticity pin made up of
steel, beat it by a hamper heavily during disassembly and get
it out.
4.32 Disassemble the fixing bolts of front fender on door
by No. 10 socket. (See disassembly of fender) and
torque is 10±1 N.m
4.33 Disassemble the fixing bolts of fender on windscreen by
No. 10 socket.
Note: You must disassemble wiper and
front cover assembly before disassemble this bolt.
Torque is 10±1 N.m
4.34 Disassemble two fixing bolts of fender on engine hood
by No.10 socket. Torque is 10±1 N.m
4.35 Disassemble fixing bolt between bumper and mudguard
by No. 7 sleeve.
Installation torque is 2±0.5 N.m
4.36 Prize the connection clip between front bumper and fender
by flat head screwdriver. Unscrew the plastic clip between
bumper
and fender by cross head screwdriver.
4.37 Unscrew two fixing bolts between fender and bumper
by No. 10 socket. Torque is 10±1 N.m
4.38 Unscrew two fixing bolts between fender and body
underside by No.10socket. Torque is 10±1 N.m
4.39 Disassemble two fixing bolts between door hinge and
body by No. 13socket and take away the front door assembly.
Torque is 36±4 N.m
5 Assembly and adjustment steps
5.1 Assemble door lock
5.1.1 Insert cable plug into lock.
5.1.2 Block the clip of inside opening cable onto lock.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст