Chery B14. Manual — part 18
2 Preparation
Tool: flat head screwdriver, cross head screwdriver, No. 7, 10 and 13 sleeve and pliers.
3 Note
3.1 To prevent accident please wear labor protection appliance.
3.2 Break down accumulator to avoid damage the electrical units.
3.3 Use the correct method to disassemble and assemble the glass
to avoid damage.
4 Disassembly/assembly steps
4.1 Disassemble door seal. The fixing clip is one type, press
upside of the seal during disassembly and push it to one direction
until one corner of the clip is exposed. And push the seal to opposite
direction until another corner is exposed. Do not drug the seal at its
perpendicular direct which will damage the seal.
4.2 Prize the plastic trim block which fix the outside rearview
mirror by flat screwdriver.
4.3 Unscrew these two fixing clips by cross head screwdriver
from front door panel.
4.4 Unscrew fixing screws from front door handle cover by cross
head screwdriver. Take off window regulator switch cable plug and
electrical rearview mirror adjuster switch plug.
4.6 Take out the cable clip of inside opening cable handle by
hand
4.7 Take off the courtesy light plug at the same time of getting
of front door panel assembly.
4.8 Disassemble two fixing screw from front door handle
cover by cross head screwdriver.
4.9 Tear down front door water proof plastic clothing.
(See disassembly of front door protecting panel assembly)
4.10 Pull out outside electrical control rearview mirror cable
plug (See disassembly of outside rearview mirror)
4.11 Unscrew three fixing bolts from outside rearview mirror by
No. 10 socket.
4.12 Prize front door inside and outside weather strip by
screwdriver.(See disassembly of window regulator system)
4.13 Connect window regulator switch to cable again and
decrease the glass to its lowest position.
4.14 Loose two fixing screws on the glass by cross head
screwdriver.
And take out the glass assembly. Torque is 2.5±0.5 N.m.
4.15 Take off up and lower fixing bolts from window regulator
by No. 10 socket. Torque is 7±1 N.m.
4.16 Disassembly three fixing bolts from window regulator
motor by No.10 socket. Torque is 7±1 N·m.
4.17 Unscrew these two fixing bolts from front glass guide
by No. 10 socket and take out front glass guide.
Torque is 9±1 N·m.
4.18 Disassemble two fixing bolts from rear glass guide by
No. 10 socket. Take out rear glass guide and glass slot
assembly. Torque is 9±1 N·m.
4.19 Unscrew four fixing screws from front door sound box
by cross head screwdriver. Take out sound box assembly.
Installation torque is 1.5±0.5 N.m.
4.20 Loose the fixing clip on door handle pull rod lock.
(See disassembly of front door lock)
4.21 Loose the fixing clip on the lock of front door lock core
pull rod by hand.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст