Chery B14. Manual — part 14
6.1.2 Take off the lock cable from engine hood.
6.2 Assembly of engine hood lock
The installing steps are reverse to those for removal.
Installation torque: 9±1Nm
7 Disassembly of engine hood lock control cable
Tool: No. 8 spanner, No.10 spanner, flat head screwdriver
7.1 Disassembly steps
7.1.1 Disassemble two fixing bolts from engine hood opening handle inside of the cab.
Installation torque: 9±1Nm
7.1.2 Take off the front cover control cable from cover.
7.1.3 Take off engine hood lock, and disassemble the
cable from engine hood lock assembly.
7.1.4 Unscrew two clips from fixing cable by flat head
screwdriver.
7.1.5 Disassemble front bumper and driver’s side
fender (see fender disassembly)
7.1.6 Take out the plug where the cable go through
to cab.
7.1.7 Take out of the cable.
7.2 Assembly steps
The installing steps are reverse to those for removal.
Note: put the slot into pulling slot during cable installation.
II. Disassembly and assembly of rear
luggage compartment lid.
1 Preparation
Tool: flat head screwdriver, No. 13 socket spanner
Material: snap clip
2 Disassembly of rear lid trim panel
2.1 Disassembly steps
Tool: No. 13 spanner
2.1.1 Take away the luggage compartment inside panel.
2.1.2 The snap clips on the inside panel are one time
using and should be carefully disassembly.
2.2 Installation of rear lid trim panel
T
he installing steps are reverse to those for removal
.
3 Disassembly/assembly of luggage compartment lock
3.1 Disassembly steps
Tool: No. 10 spanner
3.1.1 Separate the motor plug of upper lock
3.1.2 Take away three positioning bolts from luggage
compartment lock. (Installation torque is 9±1Nm)
3.1.3 Disassemble the pull rod
3.1.4 Take off control cable
3.1.5 Take off luggage compartment lock
3.2 Assembly steps
The installing steps are reverse to those for removal.
Note for installation:Observe the lock core for deformation,
the welding is correct or not, if the lock bushing is well, and
if the lock latch is flexible.
4 Disassembly of luggage compartment lock core
Tool: No. 10 socket spanner
4.1 Disassembly steps
4.1.1 Separate connect rod away from lock core
4.1.2 Loose the fixing bolt by socket spanner
(Torque is 9±1Nm)
,Take off the lock core.
Note: Do not throw away the washer of the lock core.
4.2 Assembly steps
The installing steps are reverse to those for removal.
Pay attention to assemble it to its correct position and joint
to door plate work.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст