Chery B14. Manual — part 22
4.1 Unscrew four fixing bolts for grille web cover water tank cross
beam by No. 10 sleeve.(See right figure)
4.2 Loose fixing bolts of bumper on water tank cross beam by
No. 10 sleeve.
Torque is 11N·m
4.3 Unscrew bumper two fixing screws at lower cross beam by
flat head screwdriver.
4.4 Unscrew mudguard two fixing bolts under bumper by No.7
sleeve.
Installation torque is 2±0.5 Nm
4.5 Unscrew mudguard fixing bolt beside the bumper by No. 7
sleeve.
Installation torque is 2±0.5N.m
4.6 Pull out bumper by hand from fender fixing base.
4.7 Pull out fog lamp plug by hand, and take out bumper
assembly.
4.8 Unscrew two bolts which fix shock absorber foam onto
bumper reinforcement member by No. 13 sleeve.
Torque is 3N·m
4.9 Unscrew three front bumper reinforcement member fixing
bolts and one fixing nut by No. 13 sleeve.
Torque is 25±3N.m
4.10 Unscrew bumper both sides air intake grille fixing screws
by cross head screwdriver.
4.11 Unscrew six bumper middle air intake grille fixing screws
by cross head screwdriver.
5 Assembly and maintenance
5.1 The installing steps are reverse to those for removal.
II. Disassembly/assembly and maintenance of rear bumper
1 System diagram
2 Preparation
Tool: cross head screwdriver, flat head screwdriver, No. 7 sleeve.
3 Note
3.1 To prevent accident, please wear labor protection appliance.
3.2 To prevent scratch the bumper surface paint.
3.3 Carry out the disassembly and assembly at low temperature environment, do not use big
force, otherwise the bumper will be broken.
4 Disassembly steps
4.1 Open luggage compartment lid, unscrew two fixing clips on
rear bumper by cross head screwdriver ( e.g. left side)
Front and rear bumper
4.2 Loose fixing screw and clip between rear bumper and rear
mudguard by No. 7 sleeve and cross head screwdriver.
Torque is 7N·m
4.3 Loose two lowest fixing screws between rear mudguard and
rear bumper by No. 7sleeve.
4.4 Loose fixing clip between rear bumper and body by cross head
screwdriver.
4.5 Prize rear bumper fixing clip on rear fender by hand.
4.6 Take off plugs of rear fog lamp and reverse radar probe
cable. And take off rear bumper assembly.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст