Chery B14. Manual — part 21
3.6 Unscrew two armrest bracket fixing screws by cross head
screwdriver.
3.7 Take off the water proof plastic clothing by hand.
3.8 Prize rear door outside weather strip fixing clips by flat
head screwdriver and take out the strip from one end. Take out
inside weather strip. Pay attention to that outside strip has metal
slot, and it will deform the metal slot if pull out the strip from
perpendicular direction.
3.9 Make the glass to its lowest position and loose two glass
fixing screws by cross head screwdriver.
Torque is 5±0.5 N·m
3.10 Loose front and rear glass guide fixing bolts by No. 10
sleeve
and take out of the glass guide. Take out glass assembly by hand.
Pay
attention that stand outside of car door and take the narrow side
first
and then the wide side.
Torque: Upside is 2±0.5 N·m
Lower side is 9±1 N·m
3.11 Loose the fixing bolts to fix the window regulator motor
and guide, and take out the window regulator assembly.
Torque is 7±1 N.m
3.12 Unscrew four sound box fixing screws by cross head
screwdriver, and take out sound box assembly.
Installation torque is 1.5±0.5N.m
3.13 Disassemble rear door lock assembly according to the
order to disassemble front door lock. (Disassembly of rear door
lock)
3.14 Unscrew rear door stopper fixing bolts by No. 13 sleeve
and
spanner. (Disassembly of stopper and hinge)
3.15 Loose hinge fixing bolts by No. 13 spanner and
disassemble rear door assembly. Torque is 36±4 N.m
4 Assembly and adjustment steps
4.1 Assembly of rear door glass
4.1.1 Assemble window regulator slot.
4.1.2 Assemble window regulator assembly onto the door.
4.1.3 Put the narrow side of the glass into door from outside of the door and then put the wide
side into the door.
4.1.4 Fix the glass onto window regulator by screw.
4.1.5 Connect glass regulator switch plug and rise the glass。
to its highest position.
4.1.6 Assembly glass guide.
4.1.7 For other assembly steps, please refer to disassembly
steps.
4.1.8 Rear door clearance can not be adjusted by hinge
adjustment. If the door clearance is not correct, the only way to
correct it is to correct body
(See body size)
4.1.9 Please refer to front door assembly and disassembly for
other adjustment.
Chapter Four Disassembly/Assemlby and Maintenance of the
Front and Rear Bumper
I. Disassembly/assembly and maintenance of front bumper
1 System diagram
2 Preparation
Tool: No. 7 and No10 sleeve, cross head screwdriver and flat head screwdriver.
3 Note
3.1 To prevent accident, please wear labor protection appliance.
3.2 To prevent scratch the bumper surface paint.
3.3 Carry out the disassembly and assembly at low temperature
environment, do not use big force, otherwise the bumper will be
broken.
4 Disassembly steps
Front and rear bumper
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст