Chery B14. Manual — part 23
4.7 Prize reverse radar probe by flat head screwdriver from
bumper outside.
4.8 Loose two rear fog lamp fixing screws by cross head
screwdriver and take out of fog lamp assembly.
5 Assembly steps
The installing steps are reverse to those for removal.
Chapter Five Disassembly/Assembly and Maintenance of
Front Headlamp and Fog Light
1 System diagram
2 Preparation
Tool: No. 10 sleeve and No. 7 open end wrench, cross head
screwdriver and flat head screwdriver.
3 Note
3.1 To prevent accident, please wear labor protection appliance.
3.2 To prevent scratch the bumper surface paint.
3.3 Carry out the disassembly and assembly at low temperature
environment, do not use big force, otherwise the bumper will be broken
3.4 Pay attention to the clip on the bumper during headlamp is
disassembled, big force will damage the clip.
3.5 Pay attention to not scratch the headlamp surface when
disassemble and place it .
Lights
4 Disassembly steps for headlamp
4.1
Disassemble
front
bumper
assembly
first.
(See
disassembly/assembly of bumper)
4.2 Loose headlamp two fixing bolts on engine hood cross beam
by No. 10 sleeve. Torque is 4.0±0.5N·m
4.3 Loose headlamp fixing bolt on AC condenser by No. 10
sleeve.
Torque is 4.0±0.5N·m
4.4 Loose clip seat fixing screw which is used to fix the bumper by
cross head screwdriver.
4.5 Loose headlamp fixing bolt by No. 10 sleeve.
Installation torque is 5±1 Nm
4.6 Unplug headlamp cable plug and take out the headlamp
assembly.
4.7 Screw off headlamp high beam seat cover.
4.8 Press bulb fixing clip by hand and turn it upward, take the bulb
out.
4.9 Rotate the headlamp motor of 30 degrees clockwise, and take
out the motor and cable plug.
Note: The motor can not be maintained, if make sure there is
problem on the motor, open the motor cover to see if there is gear
falling down or block phenomenon. Replace with a new headlamp
assembly if the problem can not be solved by adjustment.
4.10 Screw off low beam bulb cover by hand.
4.11 Press the bulb fixing clip by hand and take out bulb assembly.
5 Disassembly of fog lamp
5.1 Disassemble bumper assembly. ( Refer to disassembly of
bumper)
5.2 Prize fog trim cover assembly by hand.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст