Chery Tiggo 5 (T21). Manual — part 403
35–
87
35
Luggage Compartment Light Assembly
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the luggage compartment light assembly.
a. Using a flat tip screwdriver wrapped with protective
tape, pry out the luggage compartment light assembly
cover (right side).
b. Disconnect the luggage compartment light assembly
wire harness connector (arrow).
c. Remove the luggage compartment light assembly.
Installation
Installation is in the reverse order of removal.
RT21490162
RT21490163
35–
88
35
Back-up Light Switch Assembly
Removal
1. Remove the back-up light switch assembly.
a. Stop the vehicle on a lifter, and support it with the lifter.
b. Turn off all the electrical equipment and ignition switch.
c. Disconnect the negative battery cable.
d. Raise the vehicle with the lifter.
e. Disconnect the back-up light switch assembly wire harness connector (arrow).
f. Remove the back-up light switch assembly (1).
HINT:
Transmission oil may flow out when removing back-up light switch assembly. Use a container to collect the
oil.
Inspection
1. Check back-up light switch assembly.
a. Using ohm band of digital multimeter, check for
continuity between terminals of back-up light switch
assembly as shown in the table.
WARNING
Bear sure to wear necessary safety equipments to avoid accidents.
Check if safety lock of lifter is locked when performing vehicle lift repair and inspection.
1
RT21350400
ENVIRONMENTAL PROTECTION
Drained transmission oil should be collected with a recovering tool.
-
+
1
2
RT21350410
Multimeter
Connection
Switch Position
Specified
Condition
Terminal 1 -
Terminal 2
Switch pushed
Continuity
Terminal 1 -
Terminal 2
Switch released
No continuity
35–
89
35
Installation
1. Apply thread locker to the threads of back-up light, and clean the transmission oil on the area between
transmission and back-up light switch assembly before installing the back-up light switch assembly. Then
install and tighten the back-up light switch.
(Tightening torque: 20 ± 2 N·m)
2. Check if the transmission oil level is in the proper position after installation.
a. It is not necessary to do anything, if it is in the proper position.
b. It is necessary to fill transmission oil to the specified position, if it is not in the proper position (fill the oil
until it flows out of retaining plug).
35–
90
35
Hazard Warning Light Switch
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the combination switch cover (
).
4. Remove the hazard warning light switch.
a. Disconnect the hazard warning light switch wire
harness connector (arrow).
b. Press the claws (arrow) on both ends of the hazard
warning light switch by hand, and push outward
forcefully to remove it.
Inspection
1. Check hazard warning light switch.
a. Using ohm band of digital multimeter, check for
continuity between terminals of hazard warning light
switch as shown in the table.
If result is not as specified, replace hazard warning light
switch.
A/C
RT21350420
A/C
RT21350430
1
2
3
4
5
6
-
+
RT21350440
Multimeter
Connection
Switch
Condition
Specified
Condition
Terminal 1 -
Terminal 2
Switch pushed
Continuity
Terminal 1 -
Terminal 2
Switch released
No continuity
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст