Chery Tiggo 5 (T21). Manual — part 401
35–
79
35
Rear Fog Light & Reflector Assembly
Removal
HINT:
Use the same procedures for the right side and left side.
Procedures listed below are for the left side.
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the rear bumper assembly (
).
4. Remove the rear fog light & reflector assembly.
a. Disconnect the rear fog light & reflector assembly wire
harness connector (arrow).
b. Remove 4 fixing crews (arrow) from rear fog light &
reflector assembly.
(Tightening torque: 1.5 ± 0.5 N·m)
c. Remove the rear fog light & reflector assembly.
Installation
Installation is in the reverse order of removal.
RT21350320
RT21350330
35–
80
35
Front Dome Light Assembly
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the front dome light assembly.
a. Open the glasses box in the direction of arrow as
shown in the illustration.
b. Using a flat tip screwdriver wrapped with protective
tape, remove the front dome light assembly cover.
c. Remove 3 fixing crews (arrow) from front dome light
assembly.
(Tightening torque: 1.5 ± 0.5 N·m)
d. Disconnect the front dome light assembly wire
harness connector (arrow).
e. Remove the front dome light assembly.
RT21490250
RT21490260
RT21490270
RT21490280
35–
81
35
Inspection
1. Check front dome light assembly.
a. Using ohm band of digital multimeter, check for
continuity between terminals of front dome light
assembly as shown in the table.
If result is not as specified, replace front dome light
assembly.
Installation
Installation is in the reverse order of removal.
-
+
RT21350340
1
3
4
5
6
2
Multimeter
Connection
Switch Position
Specified
Condition
Terminal 1 -
Terminal 2
Switch pushed
Continuity
Terminal 1 -
Terminal 2
Switch released
No continuity
35–
82
35
Rear Dome Light Assembly
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the rear dome light assembly.
a. Using a flat tip screwdriver wrapped with protective
tape, remove the rear dome light assembly cover.
b. Remove 2 fixing screws (arrow) from rear dome light
assembly.
(Tightening torque: 1.5 ± 0.5 N·m)
c. Disconnect the rear dome light assembly wire harness
connector (arrow).
d. Remove the rear dome light assembly.
RT21490290
RT21490300
RT21490310
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст