Chery Tiggo 5 (T21). Manual — part 303
27–
16
27
Removal
HINT:
Use the same procedures for the right side and left side.
Procedures listed below are for the left side.
1. Remove the rear left wheel (
).
2. Remove the rear left brake caliper assembly (
3. Remove the rear left brake disc (
4. Remove the rear left hub bearing unit (
).
5. Remove the rear left brake assembly.
a. Fully release the parking brake control mechanism.
b. Remove the fixing clamp (arrow) and disengage the
parking brake rear cable assembly from the fixing
bracket.
c. Disengage the parking brake rear cable assembly end
(arrow) from the parking brake pulling arm.
d. Remove the coupling bolt (arrow) between parking
brake rear cable assembly fixing bracket and rear
brake bottom board assembly.
(Tightening torque: 23 ± 2 N·m)
CAUTION
Be sure to wear necessary safety equipment to prevent accidents when repairing.
Try to prevent body paint surface from being scratched during removal and installation.
RT21270100
RT21270110
RT21270120
27–
17
27
e. Remove the coupling bolt (arrow) between rear brake
line fixing bracket and rear brake bottom board
assembly.
(Tightening torque: 23 ± 2 N·m)
f. Remove the rear left brake assembly.
Disassembly
1. Remove the brake shoe stopper spring set.
a. Using needle-nose pliers, press brake shoe
compressed spring and rotate compressed spring tie
rod to remove the stopper spring sets (arrow) on both
sides as shown in the illustration.
2. Remove the brake shoe return tension spring (upper).
a. Using needle-nose pliers, remove the brake shoe
return tension spring (upper) carefully as shown in the
illustration.
RT21270130
CAUTION
DO NOT touch interior ornament when removing steering column with intermediate shaft assembly to
avoid scratching the interior ornament.
RT21270140
RT21270150
27–
18
27
3. Remove the brake shoe return tension spring (lower).
a. Using needle-nose pliers, remove the brake shoe
return tension spring (lower) carefully as shown in the
illustration.
4. Remove the brake shoe clearance adjustment mechanism assembly.
a. Disengage the brake shoe linings on both sides and
remove the clearance adjustment mechanism
assembly as shown in the illustration.
5. Remove the right brake shoe lining.
a. Disengage the right brake shoe lining from the parking
push rod as shown in the illustration.
6. Remove the left brake shoe lining.
a. Disengage the left brake shoe lining from the parking
push rod as shown in the illustration.
RT21270160
RT21270170
RT21270180
RT21270190
27–
19
27
7. Remove the parking push rod.
a. Disengage the parking push rod from the parking
pulling arm as shown in the illustration.
8. Remove the parking pulling arm.
a. Remove the parking pulling arm from the parking
pulling arm dust boot as shown in the illustration.
9. Remove the parking pulling arm dust boot.
a. Disengage the parking pulling arm dust boot from the
rear brake bottom board assembly as shown in the
illustration.
10.Remove the rear brake bottom board assembly.
RT21270200
RT21270210
RT21270220
RT21270230
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст