Chery Tiggo 5 (T21). Manual — part 302
27–
12
27
Installation
Installation is in the reverse order of removal.
HINT:
Be sure to check parking brake control mechanism stroke after installing parking brake control mechanism
assembly. Adjust parking brake control mechanism stroke to the proper position by adjusting parking brake
control mechanism locking nut if necessary.
CAUTION
Always tighten coupling bolts and nuts to the specified torque.
27–
13
27
Parking Brake Rear Cable Assembly
Removal
HINT:
Use the same procedures for the right side and left side.
Procedures listed below are for the left side.
1. Remove the rear wheel (
2. Remove the auxiliary fascia console assembly (
).
3. Remove the parking brake rear cable assembly.
a. Fully release the parking brake control mechanism.
b. Loosen the locking nut (arrow) of parking brake
control mechanism assembly to release the tension of
parking brake cable assembly as shown in the
illustration.
c. Disengage the parking brake rear cable assembly
from two grooves (arrow) on the rear of parking brake
front cable assembly.
d. Loosen the coupling bolts (arrow) between parking
brake rear cable assembly fixing bracket and body,
and disengage the cable fixing bracket.
(Tightening torque: 23 ± 2 N·m)
CAUTION
Be sure to wear necessary safety equipment to prevent accidents when repairing.
Try to prevent body paint surface from being scratched during removal and installation.
RT21270030
RT21270080
RT21270090
27–
14
27
e. Loosen the coupling bolt (arrow) between parking
brake rear cable assembly fixing bracket and rear
trailing arm assembly, and disengage the cable fixing
bracket.
(Tightening torque: 23 ± 2 N·m)
f. Remove the fixing clamp (arrow) and disengage the
parking brake rear cable assembly from the fixing
bracket.
g. Disengage the parking brake rear cable assembly end
(arrow) from the parking brake pulling arm.
h. Remove the parking brake rear cable assembly.
Installation
Installation is in the reverse order of removal.
HINT:
Parking brake should be adjusted after replacing brake shoe or parking brake cable assembly. Check if
parking brake functions properly after adjustment is completed.
Fully pull up parking brake control mechanism.
Release parking brake control mechanism and check if rear wheels rotate freely.
If wheels are difficult to rotate freely, repeat adjustment procedures.
After driving for a period of time, parking brake control mechanism stroke should be readjusted because of
wear of rear brake shoe linings.
RT21230450
RT21270100
RT21270110
CAUTION
Always tighten coupling bolts and nuts to the specified torque.
During installation, make sure to align the positioning part of parking brake rear cable assembly fixing
bracket and the positioning hole on body.
27–
15
27
Rear Brake Assembly
1 - Rear Brake Disc
2 - Rear Brake Assembly
3 - Brake Shoe Return Tension Spring (Upper)
4 - Parking Pulling Arm Dust Boot
5 - Parking Pulling Arm
6 - Parking Push Rod
7 - Left Parking Brake Shoe Lining
8 - Compressed Spring Tie Rod
9 - Brake Shoe Compressed Spring
10 - Compressed Spring Seat
11 - Brake Shoe Return Tension Spring (Lower)
12 - Brake Shoe Clearance Adjustment Mechanism
Assembly
13 - Right Parking Brake Shoe Lining
14 - Rear Brake Disc Positioning Screw
RT21270111
3
4
5
6
7
8
9
2
1
12
13
10
11
14
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст