Chery Tiggo 5 (T21). Manual — part 519
48–
34
48
Rear Bumper Mounting Bracket Assembly
Removal
HINT:
Use the same procedures for the right side and left side.
Procedures listed below are for the left side.
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the rear bumper assembly (
).
4. Remove the rear bumper left mounting bracket assembly.
a. Remove 3 fixing screws (arrow) from the rear bumper
left mounting bracket assembly.
(Tightening torque: 3 ± 1 N·m)
b. Remove the rear bumper left mounting bracket
assembly.
Installation
Installation is in the reverse order of removal.
CAUTION
Be sure to wear safety equipment to prevent accidents when removing rear bumper mounting bracket
assembly.
Try to prevent body paint surface from being scratched when removing rear bumper mounting bracket
assembly.
RT21480430
CAUTION
Be sure to wear safety equipment to prevent accidents when installing rear bumper mounting bracket
assembly.
Try to prevent body paint surface from being scratched when installing rear bumper mounting bracket
assembly.
48–
35
48
Rear Bumper Crossmember Assembly
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the rear bumper assembly (
).
4. Remove the rear bumper energy absorber.
a. Remove 2 fixing bolts (arrow) from the rear bumper
energy absorber, and remove the rear bumper energy
absorber.
(Tightening torque: 1.5 ± 0.5 N·m)
5. Remove the back door handle sensor.
a. Disconnect the back door handle sensor (arrow).
b. Using a screwdriver wrapped with protective tape, pry
up the clip and remove the back door handle sensor.
6. Remove the rear bumper crossmember assembly.
a. Using a screwdriver wrapped with protective tape, pry
up the wire harness clips.
CAUTION
Be sure to wear safety equipment to prevent accidents when removing rear bumper crossmember
assembly.
Try to prevent body paint surface from being scratched when removing rear bumper crossmember
assembly.
RT21480441
RT21480440
RT21480451
48–
36
48
b. Remove 6 fixing bolts (arrow) from the rear bumper
crossmember assembly.
(Tightening torque: 23 ± 2 N·m)
c. Remove the rear bumper crossmember assembly.
Installation
Installation is in the reverse order of removal.
RT21480450
CAUTION
Be sure to wear safety equipment to prevent accidents when installing rear bumper crossmember
assembly.
Try to prevent body paint surface from being scratched when installing rear bumper crossmember
assembly.
Front bumper crossmember assembly should not be loose, shaking and deformed after installing it.
48–
37
48
Front Wheel House Protector Assembly of Rear Wheel
Removal
HINT:
Use the same procedures for the right side and left side.
Procedures listed below are for the left side.
1. Remove the front wheel house protector assembly of rear left wheel.
a. Remove 4 fixing screws (arrow) from front wheel
house protector assembly of rear left wheel.
(Tightening torque: 3 ± 1 N·m)
b. Remove the front wheel house protector assembly of
rear left wheel.
Installation
Installation is in the reverse order of removal.
CAUTION
Be sure to wear safety equipment to prevent accidents when removing front wheel house protector
assembly of rear wheel.
Try to prevent body paint surface from being scratched when removing front wheel house protector
assembly of rear wheel.
RT21480460
CAUTION
Be sure to wear safety equipment to prevent accidents when installing front wheel house protector
assembly of rear wheel.
Try to prevent body paint surface from being scratched when installing front wheel house protector
assembly of rear wheel.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст