Chery Tiggo 5 (T21). Manual — part 520
48–
38
48
Rear Wheel House Protector Assembly
Removal
HINT:
Use the same procedures for the right side and left side.
Procedures listed below are for the left side.
1. Remove the rear left wheel house protector assembly.
a. Remove 4 plastic clips (arrow) from the rear left wheel
house protector assembly.
b. Remove the fixing screw (1) from the inner part of rear
left wheel house protector assembly.
(Tightening torque: 3 ± 1 N·m)
c. Remove the fixing screw (arrow) from the outer part of
rear left wheel house protector assembly.
(Tightening torque: 3 ± 1 N·m)
d. Remove the rear left wheel house protector assembly.
Installation
Installation is in the reverse order of removal.
CAUTION
Be sure to wear safety equipment to prevent accidents when removing rear wheel house protector
assembly.
Try to prevent body paint surface from being scratched when removing rear wheel house protector
assembly.
1
RT21480470
RT21480480
CAUTION
Be sure to wear safety equipment to prevent accidents when installing rear wheel house protector
assembly.
Try to prevent body paint surface from being scratched when installing rear wheel house protector
assembly.
Make sure damaged clips are replaced and rear wheel house protector assembly is installed in place
when installing rear wheel house protector assembly.
48–
39
48
Front Windshield Lower Garnish Assembly
Removal
1. Remove the front windshield lower garnish left cover plate (take left side as an example).
a. Using a screwdriver wrapped with protective tape, pry
up the claws on front windshield lower garnish left
cover plate.
b. Remove the front windshield lower garnish left cover
plate.
2. Remove the front wiper arm assembly (
).
3. Remove the front windshield lower garnish weatherstrip.
a. Remove the clip from the front windshield lower
garnish weatherstrip.
b. Remove the front windshield lower garnish
weatherstrip.
4. Remove the front windshield lower garnish assembly.
a. Remove 5 fixing screws (arrow) from the front
windshield lower garnish assembly, and remove the
front windshield lower garnish assembly.
(Tightening torque: 3 ± 1 N·m)
CAUTION
Be sure to wear safety equipment to prevent accidents when removing front windshield lower garnish
assembly.
Try to prevent body paint surface from being scratched when removing front windshield lower garnish
assembly.
RT21480490
RT21480500
RT21480510
48–
40
48
Installation
Installation is in the reverse order of removal.
CAUTION
Be sure to wear safety equipment to prevent accidents when installing front windshield lower garnish
assembly.
Try to prevent body paint surface from being scratched when installing front windshield lower garnish
assembly.
48–
41
48
Roof Rack Assembly
Removal
1. Remove the roof rack assembly.
a. Using a screwdriver wrapped with protective tape, pry
up the claws on roof rack center trim cover and
remove the roof rack center trim cover.
b. Using a screwdriver wrapped with protective tape, pry
up the claws on roof rack front/rear trim cover and
remove the roof rack front/rear trim cover.
c. Remove 5 fixing bolts (arrow) from the roof rack
assembly, and remove the roof rack assembly.
(Tightening torque: 9 ± 1 N·m)
CAUTION
Be sure to wear safety equipment to prevent accidents when removing roof rack assembly.
Try to prevent body paint surface from being scratched when removing roof rack assembly.
RT21480520
RT21480521
RT21480530
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст