Chery Tiggo 5 (T21). Manual — part 532
49–
39
49
11.Remove the fuel filler cap cable assembly.
a. Remove 2 fixing bolts (arrow) from the fuel tank
opening bracket assembly.
(Tightening torque: 10 ± 1 N·m)
b. Remove the fuel filler cap cable from the fuel tank
opening bracket assembly in the direction of arrow as
shown in the illustration.
c. Remove the fuel filler cap cable on the other side in
the direction of arrow as shown in the illustration.
d. Remove the clips (arrow) on the side of fuel filler cap
cable.
RT21490401
RT21490410
RT21490440
RT21490420
49–
40
49
e. Remove the clips (arrow) on the rear part of fuel filler
cap cable and remove the fuel filler cap cable.
Installation
Installation is in the reverse order of removal.
RT21490430
CAUTION
Prevent interior and body paint from being scratched when installing fuel filler cap cable.
Make sure damaged clips are replaced and fuel filler cap cable is installed in place when installing fuel
filler cap cable.
Check that fuel filler cap cable can operate properly after installing fuel filler cap cable.
49–
41
49
Rear Wheel House Sound Insulation Pad
Removal
HINT:
Use the same procedures for the rear left/rear right side and front right side.
Procedures listed below are for the front right side.
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the left C-pillar lower protector assembly (
).
4. Remove the rear wheel house sound insulation pad.
a. Remove the fixing nut (1) from the ground wire
harness.
(Tightening torque: 15 ± 2 N·m)
b. Remove the clips (arrow) from the rear wheel house
sound insulation pad.
c. Remove the clamping washer (2) from the rear wheel
house sound insulation pad, and remove the rear
wheel house sound insulation pad.
Installation
Installation is in the reverse order of removal.
CAUTION
Make sure to wear safety equipment to prevent accidents when removing the rear wheel house sound
insulation pad assembly.
Appropriate force should be applied when removing the rear wheel house sound insulation pad
assembly. Be careful not to operate roughly.
RT21490450
2
1
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст