Chery Tiggo 5 (T21). Manual — part 531
49–
35
49
13.Remove the front floor carpet assembly.
a. Take out the front floor carpet assembly from the back
door.
14.Remove the front left floor shock pad assembly (take left
side as an example).
a. Remove the front left shock pad assembly (1) from the
front floor.
15.Remove the driver side foot rest assembly.
a. Rotate the clip (arrow) on the driver side foot rest
assembly counterclockwise.
b. Remove the driver side foot rest assembly (2).
Installation
Installation is in the reverse order of removal.
RT21490351
1
2
RT21490350
CAUTION
Always pay attention to the flatness around front floor carpet assembly and the routing of relative body
wire harness when installing the front floor carpet assembly.
Spread the front floor carpet assembly according to the bottom shape without obvious bumps and
unevenness. Expose the seat installation holes, and the front floor carpet should be firmly abutted
against the bottom.
49–
36
49
Luggage Compartment Carpet Assembly
Removal
1. Remove the luggage compartment carpet assembly.
a. Lift up the band in the rear center part of luggage
compartment carpet and remove the luggage
compartment carpet assembly by pulling it outward.
Installation
Installation is in the reverse order of removal.
RT21490360
CAUTION
Make sure that the left and right sides of luggage compartment carpet are fitted in place after installing
the luggage compartment carpet assembly.
49–
37
49
Tonneau Cover Assembly
Removal
1. Remove the tonneau cover assembly.
a. Release the clamping part in the direction of arrow as
shown in the illustration to retract the tonneau cover.
b. Retract both ends of the tonneau cover assembly in
the direction of arrow as shown in the illustration, and
remove the tonneau cover assembly.
Installation
Installation is in the reverse order of removal.
CAUTION
Make sure to wear safety equipment to prevent accidents when removing the tonneau cover assembly.
Appropriate force should be applied when removing the tonneau cover assembly. Be careful not to
operate roughly.
Prevent interior and body paint from being scratched when removing the tonneau cover assembly.
RT21490390
RT21490400
CAUTION
Prevent interior and body paint from being scratched when installing the tonneau cover assembly.
The tonneau cover assembly and C-pillar lower protector assembly should be fitted closely when
installing the tonneau cover assembly.
49–
38
49
Fuel Filler Cap Cable Assembly
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Loosen the lower part of front seat belt assembly.
a. Using a screwdriver wrapped with protective tape, pry
up the front seat belt assembly lower bolt protective
cap.
b. Remove the fixing bolt (arrow) from the lower part of
front seat belt assembly.
(Tightening torque: 50 ± 5 N·m)
4. Remove the front left doorsill pressure plate assembly (
5. Remove the rear doorsill pressure plate assembly (
6. Remove the left B-pillar lower protector assembly (
).
7. Remove the rear seat assembly (
8. Remove the luggage compartment carpet assembly (
9. Remove the back doorsill pressure plate assembly (
10.Remove the C-pillar lower protector assembly (
).
CAUTION
Make sure to wear safety equipment when removing the fuel filler cap cable assembly.
Avoid damage to the interior and body paint when removing the fuel filler cap cable assembly.
RT21490330
RT21490340
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст