Chery Tiggo 5 (T21). Manual — part 530
49–
31
49
d. Disconnect the interior front dome light connector
(arrow), and remove the interior front dome light
assembly.
4. Remove the interior rear dome light assembly.
a. Using a screwdriver wrapped with protective tape,
remove the interior rear dome light cover.
b. Remove 2 fixing screws (arrow) from the interior rear
dome light assembly.
(Tightening torque: 1.5 ± 0.5 N·m)
c. Disconnect the interior rear dome light connector
(arrow), and remove the interior rear dome light
assembly.
RT21490280
RT21490290
RT21490300
RT21490310
49–
32
49
5. Remove the center seat belt outer trim cover.
a. Using a screwdriver wrapped with protective tape, pry
up the clips of center seat belt outer trim cover, and
remove the center seat belt outer trim cover.
6. Remove the sunroof weatherstrip (if equipped).
a. Open the sunroof in the direction of arrow as shown in
the illustration.
b. Remove the sunroof weatherstrip (1) by gently pulling
it along edges from one corner of the sunroof
weatherstrip.
7. Remove the sun visor assembly (
).
8. Remove the passenger grip assembly (
).
9. Remove the front doorsill pressure plate assembly (
).
10.Remove the front door opening weatherstrip (
).
11.Remove the rear doorsill pressure plate assembly (
12.Remove the rear door opening weatherstrip (
).
13.Remove the A-pillar upper protector assembly (
14.Remove the B-pillar upper protector assembly (
15.Remove the C-pillar upper protector assembly (
RT21490311
RT21470460
RT21490470
1
49–
33
49
16.Remove the roof assembly.
a. Remove 4 clips (arrow) from the roof assembly.
b. Take out the roof assembly from the back door.
Installation
Installation is in the reverse order of removal.
RT21490320
CAUTION
Make sure damaged clips are replaced and roof assembly is installed in place when installing roof
assembly.
Roof assembly and pillar upper protectors should be fitted closely when installing roof assembly.
Roof assembly and door opening weatherstrips should be fitted closely after installing roof assembly.
49–
34
49
Front Floor Carpet Assembly
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Loosen the lower part of front seat belt assembly.
a. Using a screwdriver wrapped with protective tape, pry
up the front seat belt assembly lower bolt protective
cap (arrow).
b. Remove the fixing bolt (arrow) from the lower part of
front seat belt assembly.
(Tightening torque: 50 ± 5 N·m)
4. Remove the auxiliary fascia console assembly (
).
5. Remove the front seat assembly (
6. Remove the rear seat assembly (
7. Remove the front doorsill pressure plate assembly (
).
8. Remove the front door opening weatherstrip (
).
9. Remove the rear doorsill pressure plate assembly (
10.Remove the rear door opening weatherstrip (
).
11.Remove the A-pillar lower protector assembly (
).
12.Remove the B-pillar lower protector assembly (
).
CAUTION
Make sure to wear safety equipment to prevent accidents when removing the front floor carpet assembly.
Appropriate force should be applied when removing the front floor carpet assembly. Be careful not to
operate roughly.
Avoid damage to the interior and body paint when removing the front floor carpet assembly.
RT21490330
RT21490340
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст