Chery Tiggo 5 (T21). Manual — part 529
49–
27
49
Installation
Installation is in the reverse order of removal.
CAUTION
Make sure damaged clips are replaced and C-pillar upper protector assembly is installed in place when
installing C-pillar upper protector assembly.
C-pillar upper protector assembly and rear door opening weatherstrip should be fitted closely after
installing C-pillar upper protector assembly.
C-pillar upper protector assembly, C-pillar lower protector assembly and roof headlining should be fitted
closely after installing C-pillar upper protector assembly.
49–
28
49
Sun Visor Assembly
Removal
HINT:
Use the same procedures for the right side and left side.
Procedures listed below are for the left side.
1. Remove the left sun visor assembly.
a. Disengage one side of the sun visor assembly from
holder B (1).
b. Remove 2 fixing screws (arrow) from the sun visor
assembly.
(Tightening torque: 3 ± 0.5 N·m)
c. Remove the left sun visor assembly.
2. Remove the left sun visor holder B.
a. Remove the fixing screw from the sun visor holder B.
(Tightening torque: 3 ± 0.5 N·m)
b. Remove the left sun visor holder B.
Installation
Installation is in the reverse order of removal.
CAUTION
Make sure to wear safety equipment to prevent accidents when removing the sun visor assembly.
Appropriate force should be applied when removing the sun visor assembly. Be careful not to operate
roughly.
Avoid damage to the interior and roof when removing the sun visor assembly.
RT21490210
1
RT21490220
CAUTION
Make sure to wear safety equipment to prevent accidents when installing the sun visor assembly.
Avoid damage to the interior and roof when installing the sun visor assembly.
49–
29
49
Passenger Grip Assembly
Removal
HINT:
Use the same procedures for rear left/rear right side and front right side.
Procedures listed below are for the front right side.
1. Remove the front right passenger grip assembly.
a. Using a screwdriver wrapped with protective tape,
remove the passenger grip covers (arrow).
b. Remove 2 fixing screws (arrow) from the passenger
grip assembly, and remove the front right passenger
grip assembly.
(Tightening torque: 5 ± 1 N·m)
Installation
Installation is in the reverse order of removal.
CAUTION
Make sure to wear safety equipment to prevent accidents when removing the passenger grip assembly.
Appropriate force should be applied when removing the passenger grip assembly. Be careful not to
operate roughly.
Avoid damage to the interior and roof when removing the passenger grip assembly.
RT21490230
RT21490240
CAUTION
Make sure to wear safety equipment to prevent accidents when installing the passenger grip assembly.
Avoid damage to the interior and roof when installing the passenger grip assembly.
49–
30
49
Roof Assembly
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the interior front dome light assembly.
a. Open the glasses box in the direction of arrow as
shown in the illustration.
b. Using a screwdriver wrapped with protective tape,
remove the interior front dome light cover.
c. Remove 3 fixing screws (arrow) from the interior front
dome light assembly.
(Tightening torque: 1.5 ± 0.5 N·m)
CAUTION
Make sure to wear safety equipment to prevent accidents when removing the roof assembly.
Appropriate force should be applied when removing the roof assembly. Be careful not to operate roughly.
Avoid damage to the interior and body paint when removing the roof assembly.
RT21490250
RT21490260
RT21490270
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст