Chery Tiggo 5 (T21). Manual — part 427
37–
48
37
c. Remove 3 fixing screws (arrow) from rear door lock
assembly, and remove the rear door lock assembly.
(Tightening torque: 5.8 ± 0.7 N·m)
Inspection
1. Check rear door lock assembly (fastener assembly).
a. Apply battery voltage to terminals of rear door lock assembly (fastener assembly) connector and check
if rear door lock assembly works properly according to the table below.
Rear Left Door Lock Assembly
Rear Right Door Lock Assembly
If result is not as specified, replace rear door lock
assembly.
RT21370190
RT21370200
-
+
1 2 3 4 5 6
Measurement Condition
Specified
Condition
Battery positive (+) → Terminal 3
Battery negative (-) → Terminal 2
Lock
Battery positive (+) → Terminal 2
Battery negative (-) → Terminal 3
Unlock
Measurement Condition
Specified
Condition
Battery positive (+) → Terminal 4
Battery negative (-) → Terminal 5
Lock
Battery positive (+) → Terminal 5
Battery negative (-) → Terminal 4
Unlock
37–
49
37
Installation
Installation is in the reverse order of removal.
CAUTION
Check if connector is installed correctly when installing rear door lock assembly.
Install the cable in place when installing rear door lock assembly.
Check if rear door lock operates properly after installing rear door lock assembly.
37–
50
37
Rear Door Lock Striker Assembly
Removal
HINT:
Use the same procedures for the right side and left side.
Procedures listed below are for the left side.
1. Remove the rear left door lock striker assembly.
a. Remove 2 fixing crews (arrow) from rear left door lock
striker assembly.
(Tightening torque: 10 ± 1 N·m)
b. Remove the rear left door lock striker assembly.
Installation
Installation is in the reverse order of removal.
CAUTION
Be sure to the wear safety equipment to prevent accidents when removing rear door lock striker
assembly.
Try to prevent body paint surface from being scratched when removing rear door lock striker assembly.
RT21370210
CAUTION
Try to prevent body paint surface from being scratched when installing rear door lock striker assembly.
37–
51
37
Back Door Lock Assembly
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the back door protector assembly (
).
4. Remove the back door lock assembly.
a. Disengage the back door lock mechanical opener
cable assembly from the slot in the direction of arrow
as shown in the illustration.
b. Disconnect the connector (1) from back door lock
assembly.
c. Remove 3 fixing bolts (arrow) from back door lock
assembly, and remove the back door lock assembly.
(Tightening torque: 10 ± 1 N·m)
5. Remove the back door lock mechanical opener cable assembly.
a. Disengage the back door lock mechanical opener
cable assembly (arrow) from the slot.
b. Remove the back door lock mechanical opener cable
assembly (1).
CAUTION
Be sure to the wear safety equipment to prevent accidents when removing back door lock assembly.
Try to prevent interior and body paint from being scratched when removing back door lock assembly.
RT21370220
RT21370230
1
RT21370240
1
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст