Chery Tiggo 5 (T21). Manual — part 521
48–
42
48
2. Remove the roof rack front cushion.
a. Using a screwdriver wrapped with protective tape, pry
up the claws (arrow) on roof rack front cushion.
b. Remove the roof rack front cushion from the roof rack
assembly.
Installation
Installation is in the reverse order of removal.
RT21480531
CAUTION
Be sure to wear safety equipment to prevent accidents when installing roof rack assembly.
Try to prevent body paint surface from being scratched when installing roof rack assembly.
48–
43
48
Rear Spoiler Assembly
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the back door protector assembly (
).
4. Remove the rear spoiler assembly.
a. Disconnect the high mounted stop light connector (1).
b. Using a screwdriver wrapped with protective tape, pry
up the inside rubber covers (2).
c. Remove 4 fixing nuts (arrow) from the rear spoiler
assembly.
(Tightening torque: 5 ± 1 N·m)
d. Using a screwdriver wrapped with protective tape, pry
up the outside rubber covers (arrow) and remove the
rear spoiler assembly.
CAUTION
Be sure to wear safety equipment to prevent accidents when removing rear spoiler assembly.
Try to prevent body paint surface from being scratched when removing rear spoiler assembly.
1
RT21480540
2
RT21480541
48–
44
48
5. Remove the high mounted stop light.
a. Remove 3 fixing nuts (arrow) from the high mounted
stop light.
(Tightening torque: 3.5 ± 0.5 N·m)
b. Remove the high mounted stop light from the rear
spoiler assembly.
Installation
Installation is in the reverse order of removal.
RT21480542
CAUTION
Be sure to wear safety equipment to prevent accidents when installing rear spoiler assembly.
Try to prevent body paint surface from being scratched when installing rear spoiler assembly.
48–
45
48
Back Door Upper Trim Board Assembly
Removal
1. Turn off all the electrical equipment and ignition switch.
2. Disconnect the negative battery cable.
3. Remove the back door protector assembly (
).
4. Remove the back door upper trim board assembly.
a. Remove 2 fixing screws (1) from the back door upper
trim board assembly.
(Tightening torque: 3 ± 1 N·m)
b. Remove 6 fixing nuts (arrow) from the back door
upper trim board assembly.
(Tightening torque: 5 ± 1 N·m)
c. Using a screwdriver wrapped with protective tape, pry
off the clips from the back door upper trim board
assembly.
CAUTION
Be sure to wear safety equipment to prevent accidents when removing back door upper trim board
assembly.
Try to prevent body paint surface from being scratched when removing back door upper trim board
assembly.
RT21370270
1
1
RT21370280
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст