Chery Tiggo. Manual — part 315
7. Install the lock pin (2).
8. Install the lock pin in the position shown in the fig-
ure.
CAUTION:
After the lock pin is taped in, the axle shaft
gear and the planetary gear should operate
normally.
9. Using special tools MD-998812 (1) and MB-998819
(2), install the differential front/rear bearing (3).
10. Install the driven gear of main reducing gear.
11. Apply thread sealant to the threads of all bolts.
1 - Differential Housing
2 - Lock Pin
3 - Pinion Shaft
DIFFERENTIAL UNIT REPAIR
LTSM080114
LTSM080115
LTSM080116
12. Tighten the ring gear bolts (1) in the sequence
shown in the figure.
(Tighten: Ring gear bolts to 132 N·m)
DIFFERENTIAL UNIT REPAIR
LTSM080117
08
CLUTCH SYSTEM
GENERAL INFORMATION
08-317
Description
08-317
Operation
08-317
Specifications
08-317
Special Tools
08-318
CLUTCH ASSEMBLY SERVICE
08-319
Clutch and Pressure Plate
08-319
Removal & Installation
08-319
Clutch Pedal Height
08-321
Clutch Pedal Free Travel
08-321
Clutch Master Cylinder
08-322
Description
08-322
Operation
08-322
Removal & Installation
08-322
Clutch Slave Cylinder
08-324
Removal & Installation
08-324
Bleeding Hydraulic Clutch
08-325
Operation
08-325
GENERAL INFORMATION
Description
The hydraulic clutch system consists of a clutch master
cylinder (2), slave cylinder (3), and an interconnecting
hydraulic fluid line. Hydraulic fluid is supplied by the
clutch system from the clutch master cylinder reservoir
(1).
Operation
The hydraulic clutch system is responsible for engaging and disengaging the clutch. Depressing the clutch pedal
develops fluid pressure in the clutch master cylinder. This pressure is transmitted to the integral release bearing
which is in contact with the pressure plate diaphragm spring. As additional force is applied, the bearing depresses the
diaphragm spring fingers inward on the fulcrums. The action moves the pressure plate rearward, relieving clamping
force on the clutch disc.
Specifications
Torque Specifications
DESCRIPTION
TORQUE (N·m)
Transaxle Mounting Bolts
6.9
Clutch Housing Mounting Bolts
44
Clutch Release Bearing Seat Retainer Mounting Bolts
9.8
Gear Shift Mechanism Assembly Mounting Bolts
18
Shift Gear Control Cable Bracket Mounting Bolts
18
Speedometer Gear Mounting Bolts
3.9
Final Drive Driven Gear Mounting Bolts
132
Back Up Lamp Switch
32
Idler Gear Assembly Mounting Bolt
48
Clutch Slave Cylinder Mounting Bolts
11 ± 1
LTSM080194
08
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст