Chery S11 / Chery QQ. Manual — part 92
Chery QQ Service Manual
12. Install windshield
Note:Verify that water- resisting chips have
been stuck on the face plate of car body
as showed in the drawing
(1)When install windshield,
align the reference marks
on windshield and car body, then
gently press in windshield towards
periphery
(2)Smear windshield at periphery
with bonding agent
(3)Remove excess or spilled bonding
agent with scraper
(4)Fasten windshield until bonding
agent hardened
13. Water leakage checking and maintenance
(1)Water leakage test shall be conducted
after hardening period
(2) Block up water leaking places with
sealant
14.Install upper inlaid strips on windshield
Put upper inlaid strips on car body and pat the strips by hand to tighten
bonding agent
2.7mm (0.11in)
Chery QQ Service Manual
15. Fix outside inlaid strips
Fix screws and outside inlaid strips
16. Fix front door sealing strips
17. Install the following parts:
(1)front roof lining
(2)interior rear-view mirror
(3)middle sun shading boards
(4)small illuminating light
(5)sun shading boards and holder
(6)front pillar ornament
(7)middle pillar ornament
(8)inner roof lateral ornament
(9)small rear seat lighting bulb
(10)decorative board of glove compartment
(11)assistant grasp
(12)speaker mesh guard
(13)lateral ornament of rear seat at upper parking lamp
back door frame plate
back of rear seat
Torque:18 N.m(185 kgf/cm,13 lbf/in)
bolts on the lower end of rear seat belt
Torque:43 N.m,32 lbf/in)
rear seat cushions
front seats
Torque:37 N/m(375 kgf/cm,27 lbf/in)
windshield
sealing strips for windshield
windshield wiper arms
Chery QQ Service Manual
Remove rear window glass
1. Remove the following parts:
rear seat cushions
bolts on the lower end of rear seat belt
back of rear seat
speaker mesh guard
upper parking lamp
decorative board of glove compartment
assistant grasp
small rear seat illuminating light
inner roof lateral ornament
2. Detach roof lining
3. Disconnect rear window connector
Disconnect rear window connector
4. Remove lower inlaid strips
As showed in the drawing, cut off the double-side adhesive tapes
on the two ends of inlaid strip with scraping cutter
Note: Before using, scraping cutter point shall be bandaged with
adhesive tape
Prize out inlaid strips at six clamps and take the strips down
5. Remove rear window glass
Lead piano wire out between car body and glass
Bind up two wire ends with wood blocks or similar objects
Note:Do not let piano wire damage two stops
Remove the glass
6. Remove rear window inlaid strips
Chery QQ Service Manual
Install rear window glass
1. Fixing rear window inlaid strips
Put inlaid strips on glass periphery and
fix the strips by hand
Note:Rear window glass must be removed
before fixing inlaid strips
2. Clean and finish the joint surface
of car body
Cut roughness off bonding agent sticking to
car body with knife
Note:Keep bonding agent on car body
as much as possible
Clean the cutting surface of bonding
agent with a rag soaked in cleaning liquid
Note:Even though all of bonding agent is completely removed,
car body must be cleaned
3.Remove block stop:
Remove block stop by knife
4. Clean removed glass
Remove the bonding agent stuck on glass
with scraper
Remove block stop by knife
Clean glass with cleaning liquid
Attention:Do not touch glass after cleaning
bonding agent
Block stop
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст