Chery S11 / Chery QQ. Manual — part 93
Chery QQ Service Manual
5. Position glass
Put glass in right place
Make reference marks on glass and car body
Remove glass
6. Clean the joint surface of glass
Clean the black dirt with clean liquid
on the joint surface of glass periphery
Attention:Do not touch glass surface
after cleaning
Coating a layer of base paint M
on the joint surface of car body
Brush a layer of base paint M
onto the joint surface of car body
Attention:Leave base coating layer dry
for 3 minutes at least
No coating on bonding agent
Never reserve unsealed base paint M for later use
7. Coat a layer of base paint G on the joint
surface of glass
Coat a layer of base paint G with brush or
sponge on glass periphery and joint surface
Clear base paint with a clean rag before drying
Attention:Leave base paint layer dry for
3 minutes at least
No coating on bonding agent
base paint M
base paint M
bonding agent
base paint M
base paint G
Chery QQ Service Manual
Never reserve unsealed base paint G for later use
8. Mix bonding agent
Attention:
Ensure the fixation of inlaid strip
to finish within the applicable duration of
bonding agent
Mixing bonding agent must be completed
within 5 minutes
Clean glass plate and oil loam scraper
thoroughly with solvent
Fully mix 500g principal agent with 75g hardening agent with scraper
on glass plate or similar object
9. Applying bonding agent
Cut off the tip of tubular pot and fill bonding
agent in the pot
Put the pot into sealing glue gun
Apply bonding agent on glass as showed
in the drawing
10.Install glass
When installing windshield, align the
reference marks on glass and car body, then
gently press in glass towards periphery
Smear glass at periphery with bonding agent
using scraper
Remove excess or spilled bonding agent with scraper
Fasten glass until bonding agent hardened
11. Water leakage checking and maintenance
Water leakage test shall be conducted after curing time
Block up water leaking places with sealant
Chery QQ Service Manual
12. Fix lower outside filler strip on rear window
Put inlaid strips on car body and tighten the strap by patting
Attach wire connector for defroster
Install the following parts:
roof lining
inner roof lateral ornament
small rear seat illuminating light
assistant grasp
decorative board of glove compartment
upper parking lamp
speaker mesh guard
back of rear seat
Torque:18 N.m(185 kgf/cm,13 lbf/in)
bolts on the lower end of rear seat belt
Torque:43 N.m(440 kgf/cm,32 lbf/in)
rear seat cushions
When installing, the sequence is the reverse procedure of removal
Chery QQ Service Manual
Chapter 15 Wiper
Remove front windshield wiper assembly
(1) Pull out sealing strip
(2) Prize up decorative plate
(3)Loosen set bolts and take down wiper arm
( 4 ) Loosen ten fixing screws to get out
decorative plate
(5)Prize out link rod
(6)Loosen six fixing nuts on the left and right
sides of link rod to take down link rod assembly
(7) Loosen four set bolts on wiper motor and take down the motor
Remove blade
Loosen seven set bolts and take down blade
Remove rear window wiper assembly
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст