Chery S11 / Chery QQ. Manual — part 87
Chery QQ Service Manual
Removal of front door switch
(1)Remove set bolts of front door
switch with Cross screwdriver.
(2)Take the door switch assembly out.
Removal of front door locks
institution
(1)Remove 2 set bolts on the lock
buckle with cross screwdriver.
(2)Take the lock buckle assembly out.
Removal of door check strap and set
bolts of front door
(1)Remove Bolts on door check
strap and vehicle body
- 235 -
Chery QQ Service Manual
(2)Take door check strap out.
(3)Remove front door set bolts
Adjustment of front door
1. Adjust front door frontward, backwards and vertically
Loosen the hinge bolts of body side with special tools and adjust the door.
2. Adjust the front door along left/right and vertical direction.
Loosen the hinge bolts of door side with SST and adjust the door.
3. Adjust front door lock hole
Hint: Wrap the tip of screwdriver with adhesive tape before use.
(1)Check if the door closes tightly; Check to see if the adjustment of connecting rod
of door lock is right or not.
(2)Remove the cover of lock hole.
(3)Loosen the bolts and tap the hole with hammer to adjust the position of the hole,
and then tighten the bolts.
(4)Install the bolt cover.
Removal of door glass
(1)Remove outside rearview mirror.
- 236 -
Chery QQ Service Manual
(2)Remove 2 set bolts of door glass guide rail.
(3)Separate door inner panel Assembly.
(4)Remove set bolts on upper part of
door glass guide; Take out the door inner
panel and glass guide rail.
(5)Loosen 2 set bolts of window winder and glass bracket.
(6)Take the glass out upwards.
Adjustment of door glass
Hint: Check the clearance between guide and block
(1) Lift glass completely; adjust the clearance between glass and the door inner
- 237 -
Chery QQ Service Manual
panel.
(2) Fix the guide, block and 2 nuts after adjustment.
(3)Lift glass again and check to see if the installation is good or not.
Removal of window winder
(1)Take out the door inner panel.
(2)Loosen 2 set bolts of the window winder and
glass bracket
Hint: Stuff a piece of cloth inside the door inner
panel, so as not to cut the surface of the glass.
(3)Loosen 6 set bolts of the window winder.
The tighten torque: 5.5N·m (56kg-m, 491b-ft)
(4)Loosen the harness connector of the window winder; Take the window winder
assembly out.
Removal of front door weather strip
(1)Loosen screws and nuts.
(2)Take out the two sided adhesive tape from backward with scraper.
The installation sequence is in the reverse direction of the dismantle sequence.
As to dismantle of other door, you can see “dismantle of front door” for reference.
- 238 -
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст