Chery Fora (Elara A520). Manual — part 26
Chery Service Manual for A520 Body Dimension and Accessories
7
18. The latch mechanism is as shown in the
figure:
A: Locking cable
B: Opening out control cable
C: Link the opening out push rod
D: Link the latch pull rod
Figure 62
19. Unscrew the door handle bolt 1;
Figure 63
20. Unscrew the bolt 2;
Figure 64
A
C
B
D
Chery Service Manual for A520 Body Dimension and Accessories
8
21.
Take out the door handle;
A:
Latch pull rod
B:
Opening out push rod
C:
Latch (could be replaced directly on the
vehicle)
Figure 65
22.
Remove the door check;
Assembly requirements: The tightening
torque for the bolt is 7.2±0.7N·m and the
value is 25±3 N·m while mounted on the
door pillar and 9±1 N·m while mounted on
the door. The door check should work easily,
reliable without being hit and stuck. Grease
should be applied into the room between the
pull rod and the slider of the door check.
Figure 66
23.
Remove the weather strip from the door
opening;
During installation, every corner should be
fitted in place and no folds are allowed. The
joint of weather strip should be placed in the
lower middle of the door opening. The
weather strip should have a proper rigidity
and should not interfere with the opening and
closing of the door after the lock and hinge
have been adjusted to the operating mode.
The hardness of the weather strip should be
proper without great variation with the
temperature changes. The surface of the
assembled rubber strip should not have any
defects
such
as
hammering
imprint,
deformation and warp etc.
Figure 67
A
B
C
Chery Service Manual for A520 Body Dimension and Accessories
9
24.
Remove the glass run;
Figure 68
25.
The inner harness of the door could be
taken out from outside;
Figure 69
II. DISASSEMBLING THE REAR DOOR
See left front door for considerations
during disassembling the parts
1.
Remove the trim strip from the left rear
door;
Figure 70
Chery Service Manual for A520 Body Dimension and Accessories
10
2.
Unscrew the screws to detach the inner
and outer trim panels of the triangle
glass;
Figure 71
3.
Unscrew the screw to detach the bezel for
the inside door handle;
Figure 72
4.
Unscrew the screw to detach the arm rest
cover;
Figure 73
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст