Chery Fora (Elara A520). Manual — part 25
Chery Service Manual for A520 Body Dimension and Accessories
3
Figure 50
7. Remove the protective film from the left
front door;
Figure 51
8. Remove the set screw of inside door
handle to loosen the inside control cable
and the inner retention cable;
Figure 52
Chery Service Manual for A520 Body Dimension and Accessories
4
9. Disassemble the set screws, pull out the
harness, and then detach the speaker;
Figure 53
10. Unscrew the fixing bolts from the trim
panel bracket and then dismount it;
Figure 54
11. Lower the glass to a proper position,
remove the fixing bolts, move the glass
to the bottom of door, and then take out
the glass slantways.
Assembly requirements: The glass should has
a uniform upper and lower & left and right
clearances to ensure an good fitting with the
peripheral rubber strip. The sealing of the
glass should be good without any leakage
during the rain test.
Figure 55
Chery Service Manual for A520 Body Dimension and Accessories
5
12. Unscrew the seven fixing nuts on the
inner door panel;
Figure 56
13. Take
out
the
window
regulator
assembly;
Assembly requirements: M, the torque of the
fixing bolt or nut should be 7±1 N·m. Make
sure that the glass could rise and fall
smoothly and easily without any swinging,
flapping and shocking after installation and
adjustment. Electric requirement: Time of
rise/fall not more than 5s.
Figure 57
14. Unscrew the fastening screws from the
left front door rear glass guide rail;
Figure 58
Chery Service Manual for A520 Body Dimension and Accessories
6
15. Take out the rear guide rail of the glass
from inside the door;
Figure 59
16. Unscrew the fastening bolts from the
lock with an internal spline wrench;
Figure 60
17. Loosen the latch rod and opening out
push rod of latch of the left front door to
take out the lock;
Assembly requirements: Lock sealant should
be applied at the middle of the fixing bolts of
the side door lock. The tightening torque for
the bolt is 9±1N·m. The tightening torque for
the inside door handle assembly screw is
1.5±0.15N·m while the value for the bolts of
the outside door handle assembly is 9±1N·m.
The side door should fit tightly with its
handle with reliable sealing. Be sure to
position the fastener (the tightening torque of
which is 23±2N·m) in the center of the latch
mechanism and the lock could open and
close easily.
Figure 61
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст