Chery Fora (Elara A520). Manual — part 131
16
2)
Lift down the wire harness plug.
3)
Dismantle the dynamo belt. ( The
removal methods are detailed in the
“replacement of dynamo belt”.
4)
Dismantle the intake manifold. Detailed
sequences are shown in “the removal of
intake manifold ”.
5)
Loosen the bolt (I) connecting the A/C
compressor and fixed bracket.
6)
Loosen the bolt (II) connecting the A/C
compressor and fixed bracket.
7)
Use allen wrench to dismantle the bolts
connecting the A/C compressor and
pipes.
Note: After removing the A/C pipes, you
should use clean gauze to block up the mouth
of A/C pipes in order to prevent outer
substances from falling into the A/C pipes.
8)
Dismantle the three fixed bolts of A/C
fixed bracket.
17
9)
Carefully handle the bracket and A/C
compressor, and dismantle them.
3.3
Installation steps
Installation steps is opposite to Process of
removal.
4 Replacement of Power Steering Pump
4.1
Needed tools and auxiliary materials
17#open
end
wrench,ratchet
wheel,ratchet rod, power steering oil.
4.2
Process of removal
1)
Pull out the harness plugs of power
steering switch: use17#open end wrench
and vice clamp to loosen the connecting
bolts of oil pipe and clips, and discharge
the power steering oil.
2)
Dismantle the dynamo belt. Detailed
removal methods are shown in the
“displacement of dynamo belt”.
3)
Dismantle the bolt connecting power
steering oil pump and bracket.
4)
otate the steering pump pulley to make
the fixed bolt exposed, and then screw it
off. At this time, you can dismantle the
power steering pump.
18
4.3
Installation steps
The installing steps are reverse to those for
removal.
5 Replacement of Idler
5.1
Needed tools and auxiliary materials
Ratchet wheel wrench, 13# ,15# sleeves
5.2
Process of removal
1)
Dismantle the dynamo belt. Detailed
sequences are shown in the “removal of
dynamo belt”.
2)
Dismantle the bolts connecting the idler
and engine/, and undo the idler wheel.
5.3
Installation steps
Installation steps is opposite to the Process of
removal.
6 Replacement of Air Intake Flow Sensor
6.1
Needed tools
Ratchet wheel, ratchet rod, 10# sleeve, and
slot head screwdriver.
6.2
Process of removal
1)
Pull out the plugs connecting the sensor
and wire harness, and use slot head
screwdriver to loosen the clamp at the
connection point of air intake hose and
air cleaner.
2)
Screw off the bolts connecting the
sensor and air cleaner, and then
dismantle the sensor.
19
6.3
Installation steps
The installing steps are reverse to those for
removal.
7 Replacement of Air cleaner Core
7.1
Needed tools
Right-angled screwdriver.
7.2
Process of removal
1)
Undo the clips around the air cleaner
case.
2)
Uplift the filter case and take out the
filter paper.
7.3
Installation steps
Installation steps are opposite to the process
of removal.
8 Replacement of Ignition Coil
8.1
Needed tools
Ratchet wheel, ratchet rod, 10# sleeve.
8.2
Process of removal
1)
Put the ignition switch key at the OFF
position, and pull out the ignition coil
plug.
2)
Remove the high voltage cable from the
ignition coil.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст