Chery Fora (Elara A520). Manual — part 39

15

4)

Dismantle dynamo belt (Process of
removal is shown in the “replacement of
dynamo belt”).

5)

Use 13# sleeve to dismantle the bolt (I)
connecting the generator and bracket.

2.3

Installation steps:

The Installation steps is opposite to Process
of removal.

6)

Use allen wrench to dismantle the bolt
(II) connecting the generator and
bracket, and then take out the generator.

3

Replacement

of

Air

Conditioner

Compressor

3.1

Needed tools and auxiliary materials

Small ratchet wheel, ratchet rod, 10# sleeve,
big ratchet wheel, 13# sleeve, crosshead
screwdriver, allen wrench coolant R134a,
gauze, A/C pressure gauge

3.2

Process of removal:

1)

Release Refrigerant for A/C compressor.
Screw off the nuts in the test pressure
port of high-pressure pipe, and use
screwdriver to press down the central
metal core in order to have the air
conditioner

pressure

released

completely.

16

2)

Lift down the wire harness plug.

3)

Dismantle the dynamo belt.

（ The

removal methods are detailed in the
“replacement of dynamo belt”.

4)

Dismantle the intake manifold. Detailed

sequences are shown in

“the removal of

intake manifold

”.

5)

Loosen the bolt (I) connecting the A/C
compressor and fixed bracket.

6)

Loosen the bolt (II) connecting the A/C
compressor and fixed bracket.

7)

Use allen wrench to dismantle the bolts
connecting the A/C compressor and
pipes.

Note: After removing the A/C pipes, you
should use clean gauze to block up the mouth
of A/C pipes in order to prevent outer
substances from falling into the A/C pipes.

17

8)

Dismantle the three fixed bolts of A/C
fixed bracket.

18

9)

Carefully handle the bracket and A/C
compressor, and dismantle them.

3.3

Installation steps

Installation steps is opposite to Process of
removal.

4 Replacement of Power Steering Pump

4.1

Needed tools and auxiliary materials
17#open

end

wrench,ratchet

wheel,ratchet rod, power steering oil.

4.2

Process of removal

1)

Pull out the harness plugs of power
steering switch: use17#open end wrench
and vice clamp to loosen the connecting
bolts of oil pipe and clips, and discharge
the power steering oil.

2)

Dismantle the dynamo belt. Detailed
removal methods are shown in the
“displacement of dynamo belt”.

3)

Dismantle the bolt connecting power
steering oil pump and bracket.

4)

otate the steering pump pulley to make
the fixed bolt exposed, and then screw it
off. At this time, you can dismantle the
power steering pump.