Chery Fora (Elara A520). Manual — part 20

Chery Service Manual for A520 Body Dimension and Accessories

1

CHAPTER SEVEN DISASSEMBLING AND INSTALLING THE EVAPORATOR

1. Appearance view of A21 evaporator

2. Necessary tools for disassembling

Cross screwdriver, vice, flat screwdriver, 8#
socket, ratchet gear and ratchet rod.

3. Disassembling

and

installing

the

evaporator

3.1 Replacing the blower

3.1.1 Disassembling the blower

1) Disconnect the wire connector of the

blower motor

2) Remove the mounting bolts for the

blower motor

Chery Service Manual for A520 Body Dimension and Accessories

2

3) Pull out the blower.

3.1.2 Installation

The installing steps are reverse to those for
removal.

3.2 Replacing the heater water tank

3.2.1 Disassembling the heater water tank

1) Remove the bolts and clips as shown in
the figure.

2) Pull out the heater water tank.

3.2.2 Installation procedures

The installing steps are reverse to those for
removal.

Chery Service Manual for A520 Body Dimension and Accessories

3

3.3 Replacing the evaporator core assembly

3.3.1 Disassembling the evaporator core

assembly

1)

Remove the fastening bolts for the
expansion valve and the evaporator core
assembly with an Allen wrench.

2)

Remove the three screws at the joint
position of the blower and the
evaporator housing.

3)

Remove the two screws on the rear vent
air duct to detach the rear air duct.

Chery Service Manual for A520 Body Dimension and Accessories

4

4) Remove the screws as shown in the
figure.

5)

Remove the fastening screws on the
trunk lid of the evaporator core
assembly to detach the trunk lid, and
then take out the evaporator core
assembly.

3.3.2 Installing

the

evaporator

core

assembly

The installing steps are reverse to those for
removal.

3.4 Replacing the speed regulating resistor

of the blower fan

3.4.1 Disassembling the blower fan speed

regulating resistor module

1)

Unplug the plug connecting to the speed
regulating resistor module.