Chery Fora (Elara A520). Manual — part 132
20
3)
Use 10# sleeve to dismantle the fixed
bolts of ignition coil.
8.3 Installation steps
Installation steps is opposite to Process of
removal.
9 Replacement of High Voltage Cable
9.1 Process of removal
1)
Remove one end of the high voltage
cable from the ignition coil.
2)
Pull out the connection end of high
voltage cable and sparking plug, and
dismantle the high voltage cable.
Note: If the spare parts of high voltage cable
corresponding to various cylinders are
ordered, you can replace the high voltage
cable of single cylinder; otherwise, you must
replace the assembly.
9.2 Installation steps
The installing steps are reverse to those for
removal.
21
10 Replacement of Sparking Plug
10.1
Needed tools
Carry-on wrenches
10.2
Process of removal
1)
Pull out the connection end of high
voltage cable and sparking plug.
2)
Use carry-on wrenches to screw off the
sparking plug.
Torque:
10.3
Installation steps
The installing steps are reverse to those for
removal.
11
Replacement of Camshaft Position
Sensor
11.1
Needed tools
Allen wrench
11.2
Process of removal
1)
Put the ignition key at the position of
OFF, and shut off the sensor plug.
2)
Use allen wrench to loosen the sensor
fixed bolt
11.3
Installation steps
The installing steps are reverse to those for
removal.
Installation precautions: In the case of
installation, you should apply a layer of oil
onto the O-type ring of sensor.
22
12 Replacement of Starter
12.1
Needed tools and auxiliary materials
A set of open end wrenches and a set of
sleeve wrenches.
12.2
Removal
1)
Dismantle the conductor of engine oil
dipstick. Loosen the bolts connecting
the engine oil dipstick with cylinder
block and intake manifold.
Note: After pulling out the conductor of
engine oil dipstick, you should immediately
use clean gauze to block up the hole in the
cylinder block in order to prevent outer
substances entering into the cylinder block.
2)
Loosen the two bolts connecting the
starter and transmission.
3)
Take out the starter and remove the
electric plugs of it.
12.3
Installation
The installing steps are reverse to those for
removal.
13 Replacement of Oil Filter
13.1
Needed tools and auxiliary materials
Special tools for oil replacement, engine oil.
13.2
Removal
Use special tool to clamp the oil filter, and
rotate it counterclockwise to dismantle it.
13.3
Installation
The installing steps are reverse to those for
removal. Please fill adequate engine oil after
assembling the oil filter.
23
CHAPTER III ENGINE BLOCK
SECTION I ENGINE CYLINDER HEAD
1. Structure Diagram
1. Pad-Intake Manifold
2. Intake Manifold Assembly
3. Hexagonal Flange Bolt
4. Throttle Valve Assembly
5. Gasket-Throttle Body Assembly
6. Oil Injector Assembly
7. Fuel Delivery Pipe Assembly
8. CBR Position Sensor
9. Bracket-Actuator
10. Actuator
11. Rocker 2-CBR System
12. Rocker 1—CBR System
4
8
7
6
2
12
10
1
3
5
9
11
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст