Chery B11. Manual — part 60
Maintenance Manual for Chery·Oriental Son
Engine Section
Hose
Installation Notice
O-shape seal installation
(1)Make seal ring wet to install it easily.
Caution:
There must be no engine oil or lubricate grease
on seal ring.
O-shape seal ring
Daub thermostat shell with sealant
Specific sealant:
Component of Mitsubishi brand 3M ATD
or equivalent.
Note:
(1)
Thermostat shell should be installed
immediately when the sealant is still wet (in 15
minutes).
Sealant of diameter
3mm shall be piled out
(2) Don't daub oil on the sealed part in about 1
hour after installation.
Daub engine coolant induction plug with sealant
Specific sealant:
3M ATD or equivalent
Daub engine coolant temperature sensor with
sealant
Specific sealant:
3M
ATD nut fastening or
equivalent
Maintenance Manual for Chery·Oriental Son
Engine Section
Chapter 7 Fuel Supply System
Fuel, Exhaust Gas Control
Component
Exhaust Gas Return Valve (EGR)
Remove Steps
1.Throttle body
2.Throttle body pad
3Lid
4.EGR valve gasket
5.Fuel injector & distribution tube components
6.Insulator
7.Fuel pressure regulator
8 O-Shape seal ring
9.Insulator
10. Injector
11.O-Shape seal ring
12.Grommet
13.Fuel distribution tube
Maintenance Manual for Chery·Oriental Son
Engine Section
Installation Notice
Fuel Injector Installation
(1) Before fuel injector installation, please daub
a drop of clearly engine oil on O-shape seal
ring surface, which make installation easy.
(2) Be careful enough not to destroy O-shape
seal ring when inserting the top end of
injector into fuel distribution tube.
Grommet
O-shape r
ing
Fuel Pressure Regulator Installation
(1) Daub a drop of clearly engine oil on
O-shape seal ring surface. And be careful not
to destroy the seal ring when inserting fuel
pressure regulator into fuel distribution tube.
Note:
Do not let engine oil enter into the
fuel distribution tube.
( 2 ) Check if fuel pressure regulator run
smoothly. If not, O-shape seal ring may be
locked. Please remove fuel pressure
regulator and check if the seal ring has been
destroyed. And then insert pressure
regulator into fuel distribution tube and
check it again.
Extrusion
Throttle Body Gasket Installation
(1)Install throttle body gasket as shown and
make extrusion at the position shown.
Chery·Maintenance Manual for Oriental Son
Manual Transmission
Manual Transmission – Oriental Son 7200MT
General Description
1. Reverse idler gear
2. Fourth-speed gear
3. Third gear and fourth gear synchronizer
4. Third-speed gear
5. Gearbox cover
6. Clutch cover
7. Release bearing bracket
8. Input shaft
30193
9. Output shaft
10. Differential
11. First-speed gear
12. First gear and second gear synchronizer
13. Second-speed gear
14. Fifth-speed gear
15. Fifth gear and reverse gear synchronizer
16. Reverse-speed gear
1
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст