Chery Tiggo T11 LHD. Manual — part 39

T11 Service Manual Suspension and Steering

4) Unscrew the connecting bolt and nut that joins

subframe assembly and longitudinal beam welding

assembly.

5) Unscrew the four connecting bolts that join

subframe to vehicle body.

a) Unscrew the connecting bolt (1), (2), (3) and (4)

that join subframe to vehicle body.

b) Remove the subframe assembly

Note: Prior to disassembling subframe, lift up the

engine from front compartment so as to avoid

engine from falling!

(3)

T11 Service Manual Suspension and Steering

Installation procedures:

1) Refer to disassembly procedures to perform assembly.

2) Precautions:

a) Once loosening the binding bolt whose torque and angle tightening condition is controlled by

yield limit in screw fastening, it must be replaced.

b) After installation, torque each bolt to specification.

Ⅷ Removal and Installation of Front Stabilizer Bar

T11 Service Manual Suspension and Steering

Disassembly procedures:

1) Remove the subframe assembly (Refer to removal and installation of subframe).

2) Remove the front stabilizer bar bushing (Refer to removal and installation of front stabilizer bar

bushing).

3) Remove the stabilizer bar.

Installation procedures:

1) Refer to disassembly procedures to perform assembly.

2) Precautions:

a) Once loosening the binding bolt whose torque and angle tightening condition is controlled by

yield limit, it must be replaced.

b) After installation, torque each bolt to specification.

Ⅸ Removal and Installation of Longitudinal Beam Welding

Assembly

Disassembly procedures:

1) Remove the subframe assembly (Refer to removal

and installation section of subframe assembly).

2) Unscrew the connecting bolt that joins engine

front suspension and front suspension bracket.

3) Unscrew the two connecting bolts that join

longitudinal beam welding assembly to vehicle body.

T11 Service Manual Suspension and Steering

4) Unscrew the connecting bolt that joins rear

suspension of engine to rear suspension bracket.

5) Unscrew the connecting bolt that joins

longitudinal beam welding assembly to subframe.

6) Remove longitudinal beam welding assembly

Installation procedures:

1) Refer to disassembly procedures to perform assembly.

2) Precautions:

a) Once loosening the binding bolt whose torque and angle tightening condition is controlled by

yield limit, it must be replaced.

b) After installation, torque each bolt to specification.

Ⅹ Removal and Installation of Front Drive Shaft

Disassembly procedures:

1) Remove the front steering knuckle with brake disc assembly (Refer to the removal and

installation section of steering knuckle with brake disc assembly).

2) Remove the jacket snap ring from the front drive shaft, and then draw out the drive shaft.

Installation procedures:

1) Refer to disassembly procedures to perform assembly.

2) Precautions: