Chery Tiggo T11 LHD. Manual — part 37

T11 Service Manual Suspension and Steering

harness bracket, then directly replace the shock absorber).

Installation procedures

1) Mount the new shock absorber into the

assembling fixture.

2) If it is necessary to replace the used spring,

loosen the spring, and then take out the used

spring from the spring compressor.

3) Insert the new spring into the spring

compressor, then remain one circle at the upper

part and one and a half circles at the lower part

of the spring (as is shown by the arrow).

4) Compress the spring till the distance between

the two claws is less than or equal to 120mm.

5) Confirm the position of buffer block limiter

1.

6) Fix the buffer block and pull the piston rod

to the bottom.

T11 Service Manual Suspension and Steering

7) Place the spring onto spring seat.

Important cautions:

The spring end shall be located in the spacing

hole (as shown by the arrow).

8) Fix the upper spring seat affixed with

absorber block to the position where the

punched hole offsets to tightening location of

lower spring bracket by 180

0

(As shown by the

arrow)

9) Fix the spacer bearing and localizer.

10) Tighten it by a new lock nut.

11) Tighten the new lock nut.

Important cautions: vertically use torque

wrench(as shown in the figure).

T11 Service Manual Suspension and Steering

Section 2 Front Axle and Front Suspension

Ⅰ Exterior Identification

Disassembly drawing:

——Join the control arm assembly 8 to subframe 12 with bolt 10, nut 9 and bolt 16, then torque to

specification, and the left and right side torque shall be identical.

—— Join front suspension strut 2 to steering knuckle 5 by bolt 3 and nut 4, then torque to

specification, and the left and right side torque shall be identical.

—— Join front suspension strut with knuckle assembly to the control arm knuckle pin by toothed

nut 6 and cotter pin, then torque to specification, and the left and right side torque shall be

identical.

——Respectively join the upper and lower end of front connecting rod 18 to front suspension strut

assembly 2 and stabilizer bar 14 by nut 19, and then torque to specification, and the right and left

torque shall be identical.

—— Respectively join the front and the rear subframe to vehicle body by bolt 17 and bolt 4, then

torque to specification, and the left and right side torque shall be identical.

——Make the three studs of the front suspension strut assembly 2 go through the mounting holes

T11 Service Manual Suspension and Steering

of vehicle body, then employ nut 1 to tighten them to specified torque, and the right and left side

torque shall be identical.

ⅡStructural Drawing of Front Axle

Disassembly drawing:

Left Control Arm Assembly

Front Rubber Bushing

Assembly

Longitudinal Beam Welding Assembly

Front Stabilizer Bar Assembly

Right Front Connecting
Rod Assembly

Rear Rubber Bushing Assembly

Rubber Support

Left Front Connecting Rod Assembly

Control Arm Knuckle Pin Assembly

Right Control Arm Assembly

Subframe assembly

Stabilizer Bar