Chery Tiggo T11 LHD. Manual — part 38
T11 Service Manual Suspension and Steering
Ⅲ Removal and Installation of Control Arm Assembly
Disassembly procedures:
1) Unscrew the connecting bolt that joins control
arm and subframe.
2) Unscrew the connecting bolt that joins control
arm knuckle pin and steering knuckle with brake
disc assembly.
3) Unscrew the connecting bolt that joins the rear
gum cover of control arm and subframe.
4) Remove the control arm from the vehicle.
Installation procedures:
1) Refer to disassembly procedures to perform assembly.
2) Precautions:
a) Once loosening the binding bolt whose torque and angle tightening condition is controlled by
yield limit, it must be replaced.
T11 Service Manual Suspension and Steering
b) After installation, torque each bolt to specification.
Ⅳ Removal and Installation of Control Arm Knuckle Pin
Disassembly procedures:
1) Remove the control arm assembly (Refer to the removal and installation section of control arm
assembly).
2) Unscrew the connecting bolt that joins control arm to control arm knuckle pin.
3) Remove the control arm knuckle pin
Assembly procedures:
1) Refer to disassembly procedures to perform assembly.
2) Precautions:
a) Once loosening the binding bolt whose torque and angle tightening condition is controlled by
yield limit, it must be replaced.
b) After installation, torque each bolt to specification.
ⅤRemoval and Installation of Front Connecting Rod
Disassembly procedures:
1) Unscrew the connecting bolt that joins front
connecting rod and shock absorber.
T11 Service Manual Suspension and Steering
2) Unscrew the connecting bolt that joins front
connecting rod and front stabilizer bar.
Installation procedures:
1) Refer to disassembly procedures to perform assembly.
2) Precautions:
a) Once loosening the binding bolt whose torque and angle tightening condition is controlled by
yield limit, it must be replaced.
b) After installation, torque each bolt to specification.
Ⅵ Removal and Installation of Front Stabilizer Bar Bushing
Disassembly procedures:
1) Unscrew the fixing bolt of the left and right
connecting rod bushing.
T11 Service Manual Suspension and Steering
(2) Loosen the fixing clip of balance bar bushing,
then move the balance bar forward, and finally take
out the bushing.
Installation procedures:
1) Refer to disassembly procedures to perform assembly.
2) Precautions:
a) Once loosening the binding bolt whose torque and angle tightening condition is controlled by
yield limit, it must be replaced.
b) After installation, torque each bolt to specification.
Ⅶ Removal and Installation of Subframe Assembly
Disassembly procedure
1) Remove the left and right control arms (Refer to the removal and installation of control arms).
2) Unscrew the connecting bolt that joins front connecting rod and stabilizer bar (Refer to the
removal and installation of connecting rod).
3) Unscrew the two connecting bolts (1) and (2)
that joins steering gear and subframe.
Нет комментариевНе стесняйтесь поделиться с нами вашим ценным мнением.
Текст