Chery Tiggo T11 LHD. Manual — part 43

T11 Service Manual Suspension and Steering

Ⅶ Removal and Installation of Rear Drive Shaft

Disassembly procedures:

1) Remove the rear disc brake with brake hub

assembly (Refer to the removal and installation

section of the rear disc brake with brake hub).

2) Unscrew the connecting bolt that joins rear drive

shaft and rear axle.

3) Draw the rear drive shaft out of rear axle.

Installation procedures:

1) Refer to disassembly procedures to perform assembly.

2) Precautions:

a) Once loosening the binding bolt whose torque and angle tightening condition is controlled by

yield limit, it must be replaced.

b) After installation, torque each bolt to specification.

T11 Service Manual Suspension and Steering

Ⅷ Removal and Installation of Intermediate Propeller Shaft

Disassembly procedures:

1) Unscrew the four connecting bolts that join

intermediate propeller shaft and rear axle.

2) Unscrew the connecting bolt that joins

intermediate propeller shaft bracket to vehicle body,

and then remove the bracket.

3) Draw the intermediate propeller shaft out of the

front cross universal joint.

T11 Service Manual Suspension and Steering

Ⅸ Removal and Installation of Rear Axle

Disassembly procedures:

1) Remove the left and right rear drive shafts (Refer

to the removal and installation section of rear drive

shaft).

2) Unscrew the connecting bolt that joins rear

suspension cushion of rear axle to vehicle body.

3) Unscrew the connecting bolt that joins rear

suspension cushion of rear axle and the rear axle,

and then remove the rear suspension cushion of rear

axle.

4) Unscrew the connecting bolt that joins rear axle

and the front suspension cushion of rear axle.

5) Unscrew the connecting bolt that joins rear axle

and intermediate propeller shaft (Refer to the

removal and installation section of intermediate

propeller shaft).

6) Remove the rear axle.

Installation procedures:

1) Refer to disassembly procedures to perform assembly.

2) Precautions:

a) Once loosening the binding bolt whose torque and angle tightening condition is controlled by

yield limit, it must be replaced.

b) After installation, torque each bolt to specification.

T11 Service Manual Suspension and Steering

Ⅹ Removal and Installation of Rear Subframe Welding Assembly

Disassembly procedures:

1) Remove the intermediate pipe assembly (Refer to the removal and installation section of

intermediate pipe assembly).

2) Remove the rear suspension lower control arm (Refer to the removal and installation section of

rear suspension lower control arm).

3) Remove the left and right rear drive shafts assembly (Refer to the removal and installation

section of rear drive shaft).

4) Remove rear suspension upper link (Refer to the removal and installation section of the rear

suspension upper link).

5) Remove the rear axle assembly (Refer to the removal and installation section of rear axle).

6) Unscrew the four bolts that join the rear

subframe welding assembly to the vehicle

body.

7) Remove the rear subframe welding

assembly.

Installation procedures:

1) Refer to disassembly procedures to perform assembly.

2) Precautions:

a) Once loosening the binding bolt whose torque and angle tightening condition is controlled by

yield limit, it must be replaced.

b) After installation, torque each bolt to specification.